2. digital
  3. 1005542557

DVD sound via audio-only sound system?

Can I physically connect a DVD player (not yet bought) to my stereo pre-amp? I want to run only the sound portion of movies through my stereo if possible. Also would like to play CDs on it (if I buy one).

Today I saw a Consumer Reports review of DVD players, which seemed to imply that your pre-amp needs to have either a coax or optical digital input in order to accept the sound from a CD player.

Is this true? Or do DVD players have "conventional" (i.e., unbalanced RCA-type jacks like most CD players use) interconnects? Is the digital input only required for "multichannel" (i.e., more than 2 channels), which I don't have?

Thanks for clarifying this!

- Eric
ehart
ehart OP
215 posts
 
Thanks for the reassurance guys (and for understanding my somewhat garbled question!).

- Eric
ewha
80 posts
 
Eric,

I use the new Sony DVP NS500V for CD's and DVD's in my two channel system, and it works great. FYI, I've noticed that there are increasingly more "lower end" combo players like my Sony with some great features! For example, my Sony cost $280 shipped, brand new, and it plays DVD, CD, SACD, and multi-channel SACD. Similarly, I recently saw a progressive scan DVD player from Toshiba for $250 that also plays DVD-audio. I have found my Sony to be a terrific value. I have a friend who has the higher end 9000ES DVD/SACD player. While there are obviously sonic and video differences, they are hardly worth the huge disparity in price. If you have not gotten into one of the newer formats and want to give it a try at a good price, you might want to look into some of these new products. Again, I have found that my Sony does a VERY good job as an audio-only component in my two channel setup. Happy listening!
viggen
838 posts
 
Did I read this thread correctly? DVD analog output directly connected to amp will cause damage when the signal is from a source with dolby digital?

I think you guys got it mixed up.

Most DVD players have built in processors and multichannel outputs. This allows you to connect your dvd player directly to your amp or preamp or whatever.

This seem to be pretty simple thing unless I misread something somewhere.

And yah, the left right outputs on the dvd player can be set to send out a stereo signal, surround sound signal, simulated surround sound signals, 2 channel dolby, 5.1 channel dolby and whatever the software and hardware would allow.
More to discover