Plinius M16 Phono vs. Plinius M14 Separate Phono

Hi Jmcgrogan2. My analogue rig is already pushing 20k, I don't think I will be upgrading those components anytime soon. Currently I'm having to turn the volume on my pre up past the 12:00 position to get any substantial sound out of the speakers ?? Will a separate phono stage remedy this problem ??

Thx.Trevor.

In my experience different quality phonostages make a big difference. I have the Plinius M14 today which works very nicely in my system with a LAMM LL2 preamp and was a substantial improvement over a previous system (Sonic Frontiers Signature phonstage and Conrad Johnson PV10 preamp) and an even bigger improvement over just using the phono stage in the PV10 preamp. It seems to me that you have an excellent analog front end, possibly beyond the ability of your phonostage to realize all its potential.

FWIW, I see nothing wrong with having to advance your volume control past 12 to get sufficent volume so long as when you get there, even if its at 3 o'clock your not getting to the noise threshold of your preamp. If the tone and dynamics are still holding up, and you are happy with the sound, why change? Lots of folks prefer, and manufacturers support the proposition, that a pre amp will usually sound best at about 10 to 2 o'clock, if for no other reasons that the gradiations in the volume control it self become smaller and more usable.

Trevor,
My mistake, I didn't read your system componants closely enough. I was thrown by the 'new to vinyl' first line. Forgive me. I guess your problem is you're not satisfied with the gain from your current setup. There are two ways to address this issue, either buy a phono stage that has more gain, or buy a cratridge with a higher output level.
I've checked the Plinius website, and they make no mention of how much gain the M-16's internal phono card or the M-14 has. So you'd have to e-mail Plinius and ask them this question. As a general rule though, you'll need at least 55 db of gain from a phono stage (internal or external) to drive a medium low output MC cartridge (0.5-1mV). From what information I've read on the ZYX cartridges, they seem to be very low output MC's (~0.25mV output). For cartridge with this low of an output you will probably need at least 65 db of gain from a phono preamp. So you could e-mail Plinius and find out how much gain you currently have in your M-16, and how much gain their M-14 supplies.

Bottom line, if you're not getting the sound levels you want you will need to get a higher output cartridge to mate with your current phono stage OR get a phono stage with more gain to support the ZYX UNIverse.

Think of it like the speaker efficiency/amplifier power rating combination. The less sensitive the speakers, the more amplifier power that is required to drive them.

Hopefully this is of a little more help.

Cheers,
John

Hi Jyprez,thx for your feedback. Did you audition any other phono stages before purchasing the M14 ?? If you don't mind....can you describe the sound characteristics of your M14.

Thx-Trevor.