calling all audiophiles

CFB, do you need to put on sunblock before listening to music with that amp?

Correct me if I am wrong but people seem to confuse spikes, noise and thunder. Thunder or excessive spikes are easy to control as they are usually adressed by devices in parallel with the line so they short when a high voltage hits MOV and gas tubes are usualy used. I haven't heard any comments on isolation transformers these can decouple your gear from the line which is a huge benefit (any comments?) as far as the 220V/110 comment goes this is usually a diode acting as a Voltage divider not really a benefit in my opinion.

My brother is using an isolation transformer on all of his line level components to great effect. Can't really do this with a good sized amp though, as most "reasonably priced" isolation transformers are relatively low current.

As to MOV's absorbing or shunting spikes, that is partially true. You need to keep in mind that MOV's definitely DO "burn out" or lose efficiency over time. The higher the voltage surge or spike and the more often that these devices have to deal with that type of situation, the more likely they are to fail. Just because it is plugged into a "surge protector" does NOT mean that it is "fully" protected. Sean
>

Has anyone tried the Transparent Powerlink / Powerblock Ultra units. They claim to have some outlets on them that do not limit power.

Aknorth

Hi, Wallst202. I own a monster2000 and my amp[sim4070se] is best run directly into the wall. But you can improve the performance of your 2000 by 1. setting it on bricks off the floor, 2. Going to www.musicdirect.com and buying a highwire powerwrap for $24.99. Put this on your fixed power cord to the 2000 and sit back and allow yourself an evil laugh...It raises this conditioner to a higher level....at least, in my system....I'm hearing such an ease to the presentation of the music and the backgound is dead quiet. Tiny sounds hidden behind loud sounds can be way back in the mix....good listening