2. speakers
  3. 1044332701

Question about tube friendly speakers...

I want to check my understanding of speakers. Here we have two speakers: A & B. Both of them have the same physical dimensions, use same sized woofers and woofer configurations, both have same sensitivity 90db, both handle between 25 to 200 watts, but A has an impedance swing between 4ohm and 8ohm, but B has an nominal and steady 8ohm load. And both powered by the same by, let's say, VS55 ARC tube amp.

Which will sound better with a tube amp? I think will sound better.

What if A is twice as expensive as B because of higher quality parts and build, which will match better to the amp?

Am I right?
matchstikman
matchstikman OP
205 posts
 
Audiogoners, hypothetically, based on specs alone, are the specs I provided on the speakers enough to make a theory-based choice on speakers? If not, what more is needed? Say this info will be used to build a short list of speakers to be auditioned at a later time(it would take a lifetime to audtion EVERYTHING).

Next, what kind of info is then required to know about the amp you will be using if wattage and ohm tap is not enough?
marakanetz's avatar
marakanetz
5,473 posts
 
I believe that in your case you should select the speaker with no less than 6 Ohm minimal impedace(usually rated for lowest freequencies)
c123666
871 posts
 
Audio Note Type J speakers operate between 6 and 8 ohms is what I've been advised by Audio Note. They work great with transformer tube amps. I use a P2SE with 18 watts and the SPL is way more than I can handle; plenty of power.
More to discover