Please help me get my missing frequencies
It looks like the "normal" mode sends the bass for all the speakers that you have set to "small" mode to the subwoofer. If you are running all the speakers in "large" mode, the only sounds that the sub would be fed would be the LFE channel. At least that's what i got out of reading what you posted here. This is normal and nothing to fret over. Hopefully, you've purchased speakers that are capable of low frequency output and are running them on the "large" setting. Sean > |
My Mains go down to 32Hz. But the mains do not get the LFE channel unless I say I have no sub. My dealer is on vacation and besides I don't think he is very knowledgeable, he told me that the Low Pass Filter filters out noise. I am very new to this hobby and discovered this gap in my freqs only because my dealer had told me to set my crossover to 80hz (I guess without realizing the sub will filter out anything above LP Filter which was set at like 50Hz). Recently, for experimentation purposes I set my mains to "Full Range" and heard information I never heard before in a CD I am very familiar with my system. I fixed the gap by changing the crossover to 60Hz and the LP filter to 65Hz. But that prompted me to actually read the manual (something I never do) and realized that the entire .1 goes to the Sub no matter what I set the crossover to. So now I still have a gap in my LFE channel for the freqs 65-120HZ, since the specs for LFE is up to 120Hz. |
It sounds like you've got an adjustable "rumble" filter along with a variable subwoofer crossover. If that is the case, you should be running the LP filter as low as possible or just below the point of tuning if your speakers are vented ( port, passive radiator, etc... ). The sub should be adjusted for whatever frequency gives you the best sound. This would allow the mains to play full range and then have the sub augment them as the LFE channel is called into play. Sean > |
