2. amps-preamps
  3. 1380911585

How much heat from a tube amplifier?

I am looking at picking up an integrated tube amplifier, likely the Yaqin MC-30L. It is rated for 50 wpc in ultralinear mode. Whatever one I end up getting it will be a "toy" that isn't always hooked up.

I am trying to figure out the logistics of adding it to my system. If I slide my TV to one edge of my audio cabinet there is just enough room for it to sit on top of the cabinet. The downside is that I really can't leave it there for several reasons included WAF and two small kids (9 months and 27 months old). There is room in the cabinet and the door can be easily removed to provide additional ventilation when it's used, but it appears that there would only be about 6 inches of room between the top of the amp and the cabinet. If I could use it while inside the cabinet (rather than just storing it there) I could leave the speaker cables connected to it and the SACD player connected making it much quicker to setup for use. Is it likely that it will get hot enought to damage the inside of the cabinet?

I understand that all amps are different and there isn't any way for anyone to really know the exact answer, but I'm interest in getting an idea of what you guys think.
mceljo
jjrenman
279 posts
 
I've installed a myriad of systems into cabinets and IME, you will need to get a couple of whisper type fans to exhaust the heat for any type of tube power amp. You will need one fan to exhaust the heat from the top of the cabinet. If you cut out a hole to match the chosen fan size (I prefer 4" muffin type fans) as high as possible on the back of the cabinet, as close to the amp as possible that would be best. The second fan needs to be as low as possible and mounted so that it pushes cool air into the cabinet.

If you buy 12V DC fans and a power supply that is adjustable from 6 to 12 VDC you will be able to control just how fast the fans run. In this way you will be able to fine tune between amount of air flow and fan noise. When looking at the fans you want the lowest dbu per CFM. I typically had no trouble keeping the fan noise below the noise floor in the room.

Or you can look at some cooling specialists like Active Thermal Management. (no affiliation)

BTW, proper cooling will greatly increase the amp life/reliability as well as spare the cabinet from damage.
mceljo OP
1,357 posts
 
Thanks. Was you experience with mostly closed cabinets?

Mine is at least 50 open in the back and 95% open in the front assuming the door is removed which takes about the same effort as removing a grill cover. I would have reasonable clearance on the sides as well.
donjr
1,335 posts
 
Get a solid state until your kids get older. Seriously, there's some great ones these days. I just ditched a Rogue Cronus Magnum which I loved, for a Hegel H200. I couldn't be happier.
More to discover