Best amplifier for CLX


Hi
I own Martin Logan CLX
I am looking for best amplifier for them

My front ends is all Accuphase fully balanced
I have tried most SS but not being really satisfied
Heard Soulution 700 but not in my system
JV suggests is good Match
However my experience suggests tubes unleash the full
Qualities of CLX especially the bass panels
Interested in suggestions from others experience
My room is 10 ft tall by 30 ft by 20 ft
I listen to a lot of classical large orchestral Bruckner and Mahler
Thx in Advance
Andrew
awsmone0
Bvdiman: Soulution700

Yum these will drive the 1ohm loads of the CLX's nicely, just looked at these doubling wattage for each halving of impedance even down to 2ohm, means good current drive.
At idle consumes 200w each, means a good amount of Class A bias.
96kg each, has the power supply to back up the current it gives.
The only thing I don't like is the 3.7kohm input impedance, means it should be used with ss pre's only that have at a guess no more than 50ohm output impedance, eg: Krells or probably their own.
Or better still driven direct by a CDP or DAC with <50ohms output impedance that has volume controlability and forget about the preamps, as it is just 1.5v sensitivity for full output, and all CDP/DAC are over 2v these days.

Cheers George
Thanks
I should have mentioned I have the descent sub
My issue with solid state has been they seem go give the music
Especially strings and piano a "glare"
Also they are flat in sound state in comparison with bloom and micro I get
Even with cheap valve amps
Valves give more real sound stage also
I briefly had VAC amps and they were amazing
And yes your right about the roll off with valves
However it seems to me the issue is in the mid bass with SS
With the accuphase I can measure freq response
All SS have big hole between 100 to 200 hd
Thus string and voice lack natural warmth chest and wood
This seems to be issue
Any thoughts
Awsmone0, I also own a pair of ML Monoliths that have the latest vapour deposited aluminium coatings as your CLX's have.
If you have a good front end cdp go direct if you have volume on the cdp or dac, it maybe your pre that's causing the glare.
As I use big SS amps that have masses of current and my highs and mid are very detailed dynamic transparent and sweet. Your glare as you say you have is elsewhere in the system if you have good SS amps.

Cheers George
Similar to my findings of old CLS as well as friend's CLX, although providing utmost transparency, they could sound a tad lean-ish from lower midrange on down. Hence my recommendations above are for amps be it SS or tube which give that extra weight /fullness in that region in an effort to make them sounding more fulsome and linearly balanced.

I found for SS, Soulution 710/700 to be particularly strong in that region--full lower mid, strong driving mid bass, powerful controlled lows (slight boost there, whereas Accuphase are more linear in that area), However, important to use right cabling, otherwise could be as often commonly perceived - being a tad dry/cool/soul-less etc. I found KS Elation quite a good match, but Siltech brought out the best--infusing some organic quality into them.

For tube amps, my recommendation ~ Jadis JA200, ARC REF250, VAC S450, VTL MB450 III being the minimum to handle CLXs properly and do them justice. Goodluck.