2. amps-preamps
  3. 1407646817

Distortion with ARC Ref 150 and Maggie 3.7

I have this problem that drive me nuts for quite a while. I purchased a like new fully balanced ARC Ref 150 tubes amp through Audiogon for my single ended only CAT SL1 Ultimate preamp and connected both with a RCA to XLR interconnect. It sounded okay with most recording but has awful distortion with certain recording specifically piano and vocal. Some of this recording happens almost on entire record but some only on certain musical passage. Most of the time with higher pitch or peak of music or higher volume.

For your information I listen to vinyl only most of the time and more on Jazz music. Other component listed as follow:

Turntable: Sota Nova, Tonearm: Origin Live Illustrious, Cartridge: Dynavector XV1-S, Step up transformer: Bob's Device CineMag 1131 (Blue) feeding directly to CAT's own phonostage, Speaker: Magneplanar Magnepan 3.7. Power cords, ICs, Speaker cable, Autoformer: Paul Speltz Anti-Cable.

Trouble shooting which has been done includes: checking preamp tubes condition and checking power amp bias. Since ARC claims their Ref 150 was design for balanced preamp only so I also tested by replacing it with single ended tubes amp but the distortion remain. As for the cartridge I believe I have done the alignment pretty accurate with the Mint's Best Tractor but not very sure with the azimuth.

While tested with my other 2 pair of speakers, one which has higher spec show the same problem while the lower spec one seems get rid of distortion. So I suspected the issue probably was with the new Maggie. Called the dealer and he performed a test with his transistor amp with no distortion at all. So he assumed my Maggie is okay. Is it true that the Maggie only good with transistor amps?

By now it leaves me with total confusion! Sincerely hope fellow audiophile here could give me some advice and save me from this endless misery !

Thanks very much in advance!
pakwong
atmasphere's avatar
atmasphere
11,807 posts
 
**Most of the time** you can expect an amplifier with a balanced input to work just fine with a single-ended source.

However, balanced line and single-ended operation are not normally considered to be compatible (by the pro audio industry). As a result, you usually have to jump through some hoops to make the two work together. In our equipment, that means joining pin 3 to pin 1 on the XLR and its all good. With the ARC amplifiers, the *only* way to do it is to use a transformer; Jensen makes some of the best transformers world-wide for this application.
pakwong OP
38 posts
 
Thanks Knghifi for the reminder.

Received the resistor from Audio Research and sent out the ARC 150 for trouble shooting this afternoon. Wish my technician would find out the problem with start circuit soon. In the mean time my listening room is under renovation so it's about right timing.

Regards,
zd542
5,339 posts
 
"If your house has no access to natural gas, would you buy a natural gas furnace? Post purchase, install propane and all the hassles in getting it to work."

A lot of people do it that way. Not only that, you can usually make a deal with the gas company. They'll give you the gas furnace for free, along with the install, as long as you buy the gas from them.
knghifi
1,668 posts
 
10-20-14: Zd542
"If your house has no access to natural gas, would you buy a natural gas furnace? Post purchase, install propane and all the hassles in getting it to work."

A lot of people do it that way. Not only that, you can usually make a deal with the gas company. They'll give you the gas furnace for free, along with the install, as long as you buy the gas from them.
Yes if you switch to natural gas. There's no natural gas line in my area so I have to use propane and no company is going to replace my oil furnace for free. I'll switch to propane in next MAJOR renovation.

Now I have ARC Ref250 for the winter, it should lower my oil bill. LOL!

All I get from the town is water and they are billing me $10,000+ for property tax and RISING. Can you say Detroit!
zd542
5,339 posts
 
"All I get from the town is water and they are billing me $10,000+ for property tax and RISING. Can you say Detroit!"

And the water is probably not very good. I think you should consider drilling your own well and get rid of the town altogether.
More to discover