Bo...you should change your nick in a "axegrinder"...it would suit you much better...admit to us all...B&W CEO molested you when you was a kid...while bowers not my favorite speakers definitively not as bad or 2D sounding as you describe them...or some haters on this forum...so please put the bong down and go to sleep...just my 0.02 cents...
B&W design quality observation. Any downside
I just took the baffle off a pair of B&W Concept 90 CM1's from 1991. I wanted to tighten the woofer drivers to the baffle. I was surprised to find the spider for the woofer was cast in 1 piece with the front baffle! Certainly no tightening required.(It confirmed the B&W ethic of good quality to me. The rubberized/elastic seal between baffle and speaker was also in perfect condition. I was left to tighten the tweeters to the baffle and the baffle to the body-which made a very noticeable improvement to the clarity, dynamics and smoothness of the sound
I am impressed by this design; it seems sensible when technically feasible as it absolutely eliminates any chance of loosening from the baffle-which is the bane of ALL speakers where the drive units are affixed to the baffle.
I wonder why some of these so called "ultra high end speakers (Magico, Yg Acoustics) don't use this type of design.
Is there a downside I am not considering?
I am impressed by this design; it seems sensible when technically feasible as it absolutely eliminates any chance of loosening from the baffle-which is the bane of ALL speakers where the drive units are affixed to the baffle.
I wonder why some of these so called "ultra high end speakers (Magico, Yg Acoustics) don't use this type of design.
Is there a downside I am not considering?
- ...
- 38 posts total
- 38 posts total