Any good FM tuners around for less than $200?

I am somewhat confused by analog vs digital when it comes to tuners. This is not the equivalent of tubes vs solid state, is it? Without getting really technical, what are the main differences - a dial vs a button, or....??

On another note, does anyone have experience with the Fisher FM-90X tuner? Someone has made me an offer of one. FMTuner Info mentions the tuner in their list of Fisher tuners; this is the only comment about it:

Our contributor Larry has an extensively modified FM-90-X which "sounds fabulous in mono - liquid, smooth, yet still detailed and with musical (but not authoritative) bass. This tuner has a very simple gain stage with a cathode follower, reported in many circles as being deleterious to the sound, but I find with good tubes and the mods it sounds great."

As far as I know, the tuner being offered to me has none of the 'mods,' whatever they are; the caps have been replaced with Auri caps if that makes a difference.

Holly

I had an FM-90X about 20 years ago, when it was about 35 years old. I was very pleased with its sound, and I remember it fondly. I did not do any realignment on it, and I suspect that it had never been realigned. At most I tested the tubes and replaced some, and lubricated the controls. It had no mods.

As you realize it is a mono tuner, but it provides a multiplex out jack which can be connected to an external multiplex adapter for stereo, as I described in my earlier post.

Re analog vs. digital, in the context of tuners that refers to the technology of the tuning circuitry. Analog tuners can tune continuously across the entire FM band, including the frequencies that are in between stations, while digital tuners tune in discrete steps. Analog tuners often have "slide rule" type dials and no pushbutton presets, and digital tuners often have digital/numerical frequency readouts and pushbuttons, but some analog tuners (having analog tuning circuitry) provide digital frequency readout and/or pushbutton presets.

The vintage tube tuners from the 1960's and earlier are all analog, of course.

Regards,
-- Al

Thank you for your comments on the FM-90X, Al. It sounds as if you enjoyed yours, though you have since gone on to "bigger and better" tuners. Also, thank you for the digital vs analog information - now I understand!

If I decide to go mono, I think you can also hook up the tuner so that it sends a mono signal to each speaker, correct? I hope so, because at the prices you surmise the good multiplex adapters go for, getting one would be out of my reach at the moment!

Holly

Hi Holly,

Good question, Holly. As it happens, the FM-90X has two output jacks, wired in parallel, one designated as "main" and one designated as being for a tape recorder. They are wired directly together internally, so you could connect one of those jacks to one channel and the other to the other channel.

If the component you are connecting it to includes a mono switch, though, you would just have to connect to one channel, while selecting mono mode. In that situation it would be preferable, although perhaps not necessary, to put a shorting plug on the input for the other channel.

If the tuner had not provided two output jacks, and the preamp or other component it would be connected to does not include a mono switch, you could use an inexpensive y-adapter to connect the single output jack to two input jacks.

A potentially important point, however: I don't see a preamp listed in your system description. What component would the tuner be connected to, and what is its input impedance if you know it? Vintage tube tuners, including the FM-90X, were generally not designed to drive the relatively low input impedances of many modern solid state components. If the preamp or other component the tuner would be connected to does not have an input impedance of at least 47K, and preferably more, perceptible deep bass rolloff may result if just one input channel is being connected to. And if both input channels are connected to, the load impedance seen by the tuner would be half of the specified input impedance, doubling the magnitude of that potential issue.

Also, the FM-90X does not have the kind of antenna connections that are typically provided on more modern tuners. Although it is designed to be electrically compatible with either 72 ohm coax (75 ohms should be close enough) or 300 ohm twinlead, the connector is designed to mate with narrow metal pins that are soldered to the end of the cable. You may want to ask the seller if the tuner would come with a means of mating to that; otherwise you would probably have to obtain and solder suitable pins onto the ends of your antenna cable.

Best regards,
-- Al

I do not have a preamp in my system, and my amp does not have a mono switch. My two channel system consists of an Art Audio Carissa tube power amp and Cain and Cain Abby speakers, with a Teres Audio turntable/Wright Audio tube phono stage and an Audio Aero Prima CD player. The power amp only has one set of inputs and one set of outputs so the turntable (well, the phono stage actually,) CD player and, hopefully, tuner will be connected to the power amp via a 3-position Mapletree switch box.

I didn't realize that about the antenna connections on the FM-90X; if I decide to pursue that tuner, I will ask the seller about that. I still don't have any sort of radio antenna, other than a few of those cheapie wire antennas that come with integrated receivers, but I was hoping to at least hook one of those up until I could get a 'proper' antenna.

With my setup, without a preamp, would I be better off just going for a stereo tuner? It almost seems that way to me....

Holly