How Does Gold Wire Handle?

In the interest of the thread, I should have stated my project goal--to exceed the performance of my Transparent Reference 1.5 meter XLR interconnects, purchased, about eight years ago for 4K. I have actually been fairly happy with these cables, but I really believe that, with the continued introduction of high-quality components on the DIY market this can now be achieved with careful technique and quality control.

Regarding the significance of how pin 1 is wired, I don't find it surprising that it can make a difference, although I would expect the magnitude and character of that difference to be dependent on the designs of the particular components that are involved.

Inter-chassis noise currents will inevitably flow through the pin 1 connection to some degree, due to ground loop and other effects. The magnitude and frequency characteristics of that noise will vary as a function of the resistance and inductance of the wiring that is connected between pin 1 of the two connectors. Depending on whether each of the two components connects pin 1 to its internal signal ground (which would be improper, but is often done nevertheless), or to chassis, or to chassis and then to signal ground through some impedance, some fraction of that noise current will inevitably find its way into audio circuitry, where it may intermodulate with or otherwise affect the audio signal.

Regards,
-- Al

I suspect a proper evaluation of the various alternatives would be a little tedious given that all cables really do need to undergo both burn in and cryogenic treatment. Otherwise it's just a pig in a poke. Not to mention system and location eccentricities. Sometimes copper just plain sounds better than silver no matter what you do.

Al, thanks for your concise explanation of what may be occurring through pin #1. This is very enlightening to me and, I presume, to others. There is so much opinion batted around on DIY cable threads that only seems to confuse rather than clarify. I would have continued to regard pin #1 as something of a nominal requirement, a connection made for the sake of continuity, for safety, a default run that allows me to ignore all the shielding opinions, ad nauseum. More so, congratulations--your paragraph is golden for me, the novice, and should be regarded as a breakthrough in relieving confusion for many.

Cheers,
Joe

Joe, thanks very much for your eloquently worded response. And best of luck on your project!

Best regards,
-- Al