Very Specific Ground Loop Question.


I have my turntable set up as follows:

Technics SL1600>Little Bear tube preamp>USB external soundcard device>PC

I am getting a ground loop buzz. The turntable ground wire is on the screw on the outlet that the turntable is plugged to. I have disconnected absolutely everything else and isolated just these connections above.

The interesting thing is that if I take the tube preamp out of the sequence, and substitute a little solid state preamp from radio shack, the buzz continues UNTIL I disconnect the ground wire from the outlet and don't connect it to anything else. The the hum goes away. The little solid state preamp uses 2 AA batteries.

However, when I have the tube preamp inline, disconnecting the ground wire from the outlet does not stop the buzz. I have also tried touching the ground wire to places all over the tube preamp to ground it there, and nothing stops the buzz.

So to summarize:

TT>tube preamp>computer (ground wire on outlet)=buzz
TT>tube preamp>computer (ground wire not connected)=buzz
TT>battery preamp>computer (ground wire on outlet)=buzz
TT>battery preamp>computer (ground wire not connected)=NO BUZZ

Can anyone help? I do not want to use the radio shack battery preamp.
xtom68
The turntable ground wire can also be connected to the pre-amp chassis. That is how I set up my turntable.
I tried moving the TT away from the preamp, and no change. I also tried putting the ground wire everyplace on the pre-amp I could see, including chassis, power supply, etc. No change.

Interestingly, I discovered something else. I still get ground-loop hum when the TT is disconnected completely, and this is the configuration:

Power outlet>Preamp>external Soundcard>computer

I don't know what to make of that. The computer is in a separate room from the preamp and plugged into an outlet that is on a separate circuit from the preamp, as far as I know. This is frustrating.
Here is even more information. In an effort to see if this had to do with the computer, I reconfigured to go through one of my receivers. Same effect:

TT>tube preamp>receiver (ground wire on outlet)=buzz
TT>tube preamp>receiver (ground wire not connected)=buzz
TT>battery preamp>receiver (ground wire on outlet)=buzz
TT>battery preamp>receiver (ground wire not connected)=NO BUZZ
Have you tried diconnecting the computer ?

Best thing to do is start with the amp/pre only - then add each component
to see what causes the hum

Regards

When using the receiver, is the preamp and receiver plugged into the same outlet? Also, I'm assuming the computer is not connected in any way?