Thoughts on Audio Research D70

I pulled the trigger on an ARC D70mk2 about a year ago..here are my thoughts on it: http://forum.audiogon.com/cgi-bin/frr.pl?ramps&1277362082&&&/Audio-Research-D-70-mkII-Tube-amp-

Agree with Tubegroover, I do not think one can buy a better tube amp on the market for anything near the price. Don't agree that the amp lacks ultimate detail, air or bass control of more expensive tube amplifiers. In an 'AB' with a BAT VK75 amp of recent vintage, all preferred the ARC and by no small margin. I do think that everything else in the system has to be up to what the D70 can bring to the table.

No doubt it's a good amp. The D115mkll has a bit more drive, dynamic range, and slam in the bass.

Indeed the D-115 Mk 2, which I owned for several years and is currently used by a friend in his system, has great bass drive and slam and is very dynamic HOWEVER it has less control and definition in the low bass than my current amp or some others I have listened to in my system. Also the presentation is a bit less airy, missing some of the ambient detail of some more resolving amplifiers. The D70 and D115 fall into the general category of "classic tube sound", a little rounder on the leading edges and thus can sound a bit fuller AGAIN a preference issue as often is the case in these matters. When more resolution is gained poorer recordings can come off as harsher than with a somewhat more forgiving amp. To be honest I could easily live with his amp as he has owned it for 12 years and done quite a bit to enhance its performance, again a great choice but still not as ultimately resolving as some that I've had in my system (all OTL's btw) but not enough of an issue to fret over for sure. Preferences and taste always comes more into play than absolutes but on balance these are truly excellent products and have aged quite well.

Thanks for the opinions. Now to find an old beat up unit for an affordable price so I can do a complete rebuild.

Found a D115 mkii. Can't wait to hear how it sounds.
Will definitely verify each test points voltage and go through the usual hexfred/schottky diode mods and coupling cap upgrades... then triode of course.
The circuit begs for a better driver tube than 6FQ7.
Will see if filament supply can support 6H30 (driver and power tubes have AC filament).