magepan 1.6's with mac ma6500 integrated

I am not specifically familiar with the Mac MA6500 but
I am knowledgeable about the Magnepan 1.6's which I've
owned for 3 years (with other Magnepans in the past).

I would venture to say that ANY integrated amp will not
do justice to 1.6QR speakers, unless you listen at low
volume levels. Even then you won't have the dynamics
and bass fullness which can be obtained with adequate power.

Magnepans in general and 1.6's in particular are demanding
of equipment. To generalize, the more power the better.
I had been using a Mark Levinson 27.5 amp (200 W/Chan). This
is a highly regarded power amp, but with the 1.6's the
dynamics were constricted and the sound became
two-dimensional at high volume. I replaced the 27.5 with a
Levinson 335 (500 W/Chan) and it opened up the speakers
considerably.IMO 200 W/Chan is the minimum for 1.6's. I
don't think even the Levinson 383 integrated would be
adequate. Occasionally I've read complaints about 1.6's
sounding "bad" and it's often because of inappropriate
amplification. I would recommend a high-current poweramp
of your choice.

If you room is small, the 6500 is probably fine but you may want the extra power of the 6900 otherwise. The Mc and the Krell are like apples and oranges so it will depend on your tastes as to which you will prefer. There are several happy Mc & Maggie owners on this forum.

my room is small -- 11 x 15, i do have a sub. a rel storm iii.