Postive or Negative Results -Big Amp & Conditioner

Hi Joe
I have until recently run a Krell FPB 200 through an Audiophile APS 1050 mains regenerator with excellent results. Way better than just plugged direct to the mains, no compresion of sound no softening or bluring of either the bass or high frequencies. In conclusion no exagiration of any aspect of the sound. Just all round better results, worth the cost. No problems during powering the Krell up when the massive Tx and caps charge and energise up.
Hope that helps,
Andy

Audphile1, please state which Hydra you were using. You will notice that I recommended the Hydra 2, as I have found that this is the best Hydra for a high powered amp application. Yes, the other Hydra's with their added circuitry, can slow down amp speed.
Just like I didn't recommend any RSA power conditioner. The RSA Duke is by far the best RSA product for a high powered amplifier. Make sure you try the right conditioner for the right job before you nix the whole product line.

Jmcgrogan2, I don't know why, but you sound kind of agravated.

I always speak highly of Shunyata products. I think they make very good stuff. I'm not trying to nix the whole product line. I am surprised to see you are taking this rather personally.

I have my system listed and all it takes is a click of a mouse to find out what hydra model I was talking about.
It appears that you'd rather type than click, so I will answer your question. I am using Hydra4. You can see it in my system if you click on it.
I had Hydra2 but that was when I had the McCormack amps and Hydra2 was good. Hydra4 is good with McCormack amps as well. I used it and my friend uses it and the McCormack sounds better with Hydra. Not the case with my Pass Labs amp though. However, I never tried Hydra2 with the Pass, because my the time I bought the Pass amp, I sold my 2 Hydra2 units to get 2 Hydra4.
This may be a screw up on my part because I am not using Hydra4 for the amp and I have 2 outlets in the Hydra4 that are not utilized. I could have easily get by with a Hydra2.

Also, I replied because we are talking about a Pass Labs amp. I have X250.5 and I beleive it is similar in design to the amp in question, the X350.5. Therefore I decided it was appropriate to share my experience.

Your reply is pertaining to BAT using Hydra2 may or may not apply.

That is why the first line of my reply was

It's very simple. It depends on the amp. You have to try it to determine if it works or not. That's all.