Bridged amp with electrostatics..

I think that there is a confusion of semantics here. Carlos is, I think, talking about bridging a stereo amp to provide more power for a single channel. Some amps are delivered from the factory with a switch to allow "bridging". I am showing my ignorance, perhaps, but I do not think that that is the same think that Atmasphere is referring to. Take this with a grain of salt, because I know nothing about circuit design (but I do know that the tube amps he mentions sound great).

Sorry I may bring some confusion; I am keen to buy a MF KW amplifier, there are two models. One is integrated delivering 650W and theother is a power amplifier only delivering 750W; both are bridged per se,by design and non-reversable.

I have recommended this amp alot. Moscode 401hr. I use it with electrostatics. Bridging is acomlpished with a flip of the switch. I am sure you mean bridging and not biamping.Biamping is where you use a different amp for the top and the bottom.

That's right Gregadd, the amp in question is the MF KW500 integrated and it is built in as bridged...I still look for sombody that has a bridged amplifier/s that uses for electrostatics, what are the precautions?
Thanks all of you.

because elctrostats are power hungry, I have never heard anyone blow there speakers because of too much power. More likely the panels could "bottom out" by trying to drive them to hard. I do not know whawt speakers you have. If they are under warranty you definitely should consult the manufacturer. Just use the normal precautions.