2. amps-preamps
  3. 1179615335

yamaha cx-1000u rs..can I run 2 subs?

I am wondering if I can hook up 2 subs useing this pre amp.I know its old.But you have to start somewhere.The manual doesn't say squat about subs,and I don't know too much about hooking them up.I have a wharfedale power cube 10 running on my ht setup.Thinking of useing that and maybe getting a svs pb10 nsd.Any input would be gr8!
ralphnoonan
ralphnoonan OP
21 posts
 
yup seperate pre and amp..and I think I'm getting this now.So if I have two amps connected through my 1 and 2.Where would i connect a sub,or 2?I can use my tape 1,2 or 3 for this?
gregadd
574 posts
 
my first choice is to put it between the preamp and amp of the system sub is serving. Try putting it between output 1. As always turn everything off. turn volume down. Power up slowly. Stay near the volume control and on/off switch. Any thing that sounds amiss turn volume down and shut off immediately. Your subsystem should have some advice on this.
rwwear
2,885 posts
 
If you have two pair of outputs for an amp, it would be best to use one pair of those to the subs. Y cables will work if you only have one pair of outs.
ralphnoonan OP
21 posts
 
Thanks for all the info.
gregadd
574 posts
 
did you get it up and running?
More to discover