MC TRANSFORMERS VS TUBE PRE PRE


Has anyone here had much experience comparing mc step-up transformers vs. tube pre pre amps? Several things conspired together to cause me to send my Counterpoint SA-5.1 to Alta Vista in order to have the Sowter 8055 transformers installed. I own a Counterpoint SA-2 pre pre amp which was simply magical with the SA-5.1. Unfortunatly, my SA-2 broke and then my listening room was flooded out (thus the conspiring events). When my listening room flooded, I decided to take the "opportunity" of my music downtime to send the 5.1 back to Mike and have the Sowter mc transformers installed as an "upgrade" and then not have to worry about having the SA-2 repaired. After all, the Sowters' were supposed to far superior to the SA-2 and it would remove a bunch of tubes from my system by replacing the SA-2. Well, my listening room was fixed from the flood and slowly my system came back together again. When I installed the SA-5.1 back into the system with the Sowters' now in place, I was bummed to say the least. The magic was gone. In its place was a homogenized, dumbed-down version of what my LPs used to sound like. Had I not known any better (i.e.; I didn't know what information was really on my records), I would think the Sowters' sounded really good. However, I do know better. My question to the forum is does anyone else have any experience going from a quality tube pre pre and switching to transformers? I don't mean to pick on Sowters' in particular, they are just what I have installed and Mike feels they are the best of breed. I am beginning to think that the problem lies in using any mc transformer. At this time my SA-2 is in route back to Alta Vista to be fixed. I am going to send my SA-5.1 back and have the Sowters' removed and my phono stage restored to the way it was. I want the magic back that I had. And the magic that I am speaking of is the difference between your system sounding like live musicans are playing in front of you with all of the dynamics that implies vice having a system that sounds very "nice" in the usual audiophile sense that would impress people who didn't know better. For the record, my system consists of the VPI TNT MKIII with the new 300 RPM motor, ET-2 tonearm, Denon 103R cartridge which replaced my Van den Hul MC-2 special which it simply smokes, Counterpoint SA-5.1 pre, and Quicksilver MS-190 amp on the main speakers. I have a DBX electronic crossover that feeds a pair of Denon POA 6600A monoblocks for the subs. My speakers are my own designs. They are all (main speakers and subs) 1/4 wavelength transmission lines. Bottom line is that before I ever take another blind alley on "upgrades," I want someone to come to my house and show me that what they have is better. For the here and now, I would step over all of the mc transformers out there in order to get my hands on a SA-2. And if anyone has heard another pre pre that bests the SA-2, please let me know what it is. One last tid bit. If you have a British copy of the Beatles lp Abbey Road, listen to the beginning of Sun King. Let me know if you can hear Ringo hitting the cymbals with a mallet, and if you can hear pressure waves coming off each of those strikes with differing dynamics. If the answer is no, it just sounds like cymbals being hit, you are in the "missing information" catagory which is where I am currently back to with mc transformers.
mepearson
A discussion on xformers vs preamps would not be right without Rauls's input. It is a discussion that should have been made moot by the existence higher output MC's and higher gain preamps. Yet there remains many vintage preamps and new carts that seem to go lower and lower in terms of output level. Suffice it to say Raul can't abide anything but ruler flat frequency response. I can't abide noise. Morevoer ther is simply so much magnification of anything you can do by conventional means before you begin to distort.

This makes xformers for those low output mc's with vintage preamps,not only a good choice but sometimes the only choice.
It is often the case that hich output MCs just don't sound as good as the lower output versions.
SUT's can have a characteristic sound or influence on cartridges. Shopping for one that works well with your setup can be tedious. If you have one that has a character that you don't like, then it will irritate you and eventually you will not live with it. However, if you find one that is a good match with your cartridge, system and setup, you won't want to listen to anything else and you probably won't find any tube or SS stage you like better. Aficiandos find that SUT's give "flow" to the sound and a spectral character that matches well with MC's, it's not just a matter of flat response or noise. Once you have found a good sounding SUT, you might find an active stage a little obtunded and unnatural by comparison, whether it be tube or transistor. Tone control? Maybe, but it is the difference between something that works well sonically in practice vs. something that just works in theory.
Cjfrbw-I don't agree with your defense of transformers, but then that is why we have this forum. I find the exact opposite to be true of your last two sentences. I find the SA-2 to be very natural by comparision to the Sowter 8055 transformers and it works very well "sonically" vs. the transformers that work "in theory." The SA-2 absolutely passes more information in a way that sounds like live music is being played in your room than the Sowter 8055s could dream of. In addition to soundstage abberations induced by the tranformers, the overall loss of information they cause homogenizes the sound of all recordings that pass through them. Mediocre recordings still sound mediocre, but unfortunately, really good sounding recordings also sound mediocre (in comparision to how they really are capable of sounding). Tranformers are a cheap method of stepping up the voltage of a low output mc (and when I say cheap, I mean they SHOULD be much cheaper than well made active gain stages-specially a tube gain stage with a tube power supply, but I know there are absurdly priced transformers just as there are absurdly priced wire and cables which is another discussion), but they don't sound like their active stage brethren. You may have less noise with transformers, but you also have less information and less music. I will trade a little more noise for a lot more music any day. Nothing is perfect in this wacky hobby of ours, but I will vote for more information from the grooves that is true to the source every time.
I have yet to hear a transformer that can do what a proper tube phono stage that is capable of MC operation can do on its own. The transformers rob detail, bandwidth and are less interesting to listen to.