Is my amp "High Current"?

Inpep, you still appear to misunderstand the the terms voltage, power and current, and more important, how they relate to each other. If you will spend some time with this site:
http://www.allaboutcircuits.com/vol_1/index.html
until these relationships are second nature, you will understand what I am trying to say.

Speakers (with voice coils, and primarily woofers) need power (watts) if it takes work to move them (power = voltage x current.) BUT, they need those watts (power) to come primarily from a larger reservoir of voltage since voltage drops as power is consumed. An ESL needs power too, but from a reservoir of current. As the frequency rises and the impedance drops, yes, they need power too, but they are going to draw current out of those watts to maintain the strength of the static charge on the membrane. They don't need volts for that!

All amplifiers supply BOTH increasing voltage AND current as the volume (input signal to the amp) is increased. The maximum output of the amp (in watts) is a product of its max. voltage times its max. current, and those two can be in ANY proportion. But with tube amps, current is usually in larger proportion to voltage than in ss amps where it's the reverse. I just don't know how to say it any more clearly.
.

Nsgarch, this discussion is getting nowhere precisely for the reason that you think that my understanding of power etc. is faulty, when in fact I can say the same for your understanding.
I guess my fault is in trying to explain in layman's terms what the relationship is among power, potential and current.
let's leave it at that.
One lat note, though. I am not the only person who pointed out that your understanding was reversed.
respectfully, Bob p.

Bob, so far, no one has explained just what it is that's "reversed" about my description(s). I am just using Ohm's Law as it exists for all circuit design. And although I'm still confused as to the point you're making, my point is simply that if you are driving an ESL, you can enjoy equal performance with either a ss or a tube amp, but you'll have a lower electric bill (use less watts) using the tube amp. Conversely, if you want to drive a speaker with a lot of electomagnetic drivers, a SS amp will use a lot less power (from the electric company) than a tube amp capable of delivering equivalent performance. Maybe I didn't make that clear at the beginning ;-)

That the discussion was about about amp efficiencies, no you hadn't made that clear.
Tube amplifiers are always less efficient in producing power, it is inherent to their nature and independent of the speaker load or type (ESL or dynamic). I.e., for the same power output, tube amps consume more power (from the electric company) than a SS, even a Class A SS.