Which Super Integrated Amp to drive planars?


So, i've narrowed down my shortlist to the below amplifiers to drive my LFT 8B Planar speakers. These are all big powerful integrated amps - having a preference of integrateds at this pricepoint. My source is an Esoteric SA60. I play nearly all music genre.

Can any forum members share their views / experience with any of the below mentioned amps - preferably where driving difficult / low sensitivity (84dB or less) full range speakers? Comments on the synergy between the above and below mentioned products also deeply appreciated.

Super Integrateds (High Power products only)

BAT VK-300X SE -------------------[150w 8ohm, 300w 4 ohm]
Coda Continuum CSI ltd edition --[220w 8ohm, 440w 4 ohm]
Krell 400xi --------------------------[200w 8ohm, 400w 4 ohm]
Pass Labs INT-150 ----------------[150w 8ohm, 300w 4 ohm]
Unison Research Unico 200 -------[200w 8ohm, 350w 4 ohm]
Boulder 865 Integrated -----------[150w 8ohm, 300w 4 ohm]
Sim Audio Moon i-7 ---------------[150w 8ohm, 250w 4 ohm]

Thanks
kiwi_1282001
Which spkrs are you driving? It helps to know -- otherwise, how can one recommend a specific amp?

My speakers are Eminent Technology LFT 8B.
03-14-08: Douglas_schroeder
Here's something different for you; take a look at the twin Pathos Classic One MkIII tube hybrid integrateds that I'm using. 270w into four ohms bridged, super-clean signal path as you run directly from source into the integrateds. You lose a preamp and one set of IC's, but you gain mono block operation for channel separation and power with a tube pre stage and SS output stage.

Wow Doug, that is something different. Thanks for the insight. Does this mean you have two volume controls to set each time?
Kiwi, Ah, I got your attention, did I? It is a most unusual, and excellent performing set up! I like trying alternative methods as they sometimes yield wonderful results.

If the two units are within three feet or so of each other you will have no issues with running them in lockstep via the remote control. It is uncanny how perfectly the two work in synchony, almost like there is a physical link between them.

Other good aspects include the availability of running one stereo if some other component in a diffeent system craps out. You also have a second remote handy in case the first dies. And the fantastic looks! (If I said that before, it's worth repeating!) :)

I also use the Pathi with Legacy Audio Focus HD's, which are 96dB sensitivity, and that also is a fantastic sounding combo.

I would love it if more manufacturers produced integrateds which were switchable to mono block. Since this integrated is designed well enough to be run as a mono block amp the results are impressive. From my experience the benefit of losing an additonal component and set of IC's allows for this more modest integrated to perform at a higher level than expected. In my opinion it is the best of separates and integrateds, with virtually no downside. You even get the potential to tube roll at a very minimal cost!
I guess I accidentally put a double link for the LFT-8B above; meant to put the link to the twin Pathos amps article there. Here it is:

http://www.dagogo.com/PathosClassicOneMkIII.html
I have been using the CODA CSi Limited Edition since last June and love it from top to bottom. It drives my Tyler Woodmere 2's with ease (4 ohm load, occasionally dropping to 2 ohms; 87db claimed sensitivity). The CODA CSi Limited Edition has never flinched, even when delivering the most demanding source material at high volume.

All fully remote controlled, the CODA has no knobs. It plays wonderfully sweet, full-sounding music at all frequencies, and the amp is dead quiet even at high volume. Not the slightest hum or hiss. I cannot compare it to your other considerations, but I can attest to this amp's musical truth and power. In addition, the folks at CODA were a pleasure to deal with.

Please feel free to ask any specific questions you like, and I will try to answer them.