It sounds like you're describing the difference between SS and tube amps. Have you thought about trying tubes? It might be worth exploring. Personally, I haven't found an SS amp that gives the kind of midrange warmth that tubes do.
Check out Soundlab's FAQ:
What is the Minimum Power that you Recommend?
I personally recommend 100 watts minimum. However, we have customers that use 30 watt single-ended triode amplifiers and find them to be satisfactory. The equivalent one-meter sensitivity of our speakers (measured at 4 meters) is approximately 88 to 100 db (depending on the equalization settings). This is typical of the more efficient high-end speakers.
Which type of Amplifier works best, Tubes or Solid-State?
The real question is, which do you prefer? The high-impedance of our speakers in the lower frequencies (where the musical spectrum is most demanding) results in a greatly reduced current drain from the amplifier. So, both types of amplifiers run cooler, exhibit less distortion and last longer. Our speakers are very neutral and are not prejudiced, so what you prefer sounds best.
Check out Soundlab's FAQ:
What is the Minimum Power that you Recommend?
I personally recommend 100 watts minimum. However, we have customers that use 30 watt single-ended triode amplifiers and find them to be satisfactory. The equivalent one-meter sensitivity of our speakers (measured at 4 meters) is approximately 88 to 100 db (depending on the equalization settings). This is typical of the more efficient high-end speakers.
Which type of Amplifier works best, Tubes or Solid-State?
The real question is, which do you prefer? The high-impedance of our speakers in the lower frequencies (where the musical spectrum is most demanding) results in a greatly reduced current drain from the amplifier. So, both types of amplifiers run cooler, exhibit less distortion and last longer. Our speakers are very neutral and are not prejudiced, so what you prefer sounds best.