2. amps-preamps
  3. 1209864603

pre-amp unacceptable noise level?

How much is an unacceptable level of noise/humming etc. from a pre-amp? I just bought a new tube pre-amp and when I replaced my old solid state one with it the noise level from the speakers practically tripled. There is an audible humming from the listening chair 10ft. away. I can't say I'm particularly happy with this considering the one I replaced did not do this.
fruff1976
sugarbrie
3,854 posts
 
You do not need to bias the tubes with preamps.
The cheater plug would go on the power amp, if that is the problem.
Is it both channels or one? If one, you might have a bad cable.
If the hum is there with both preamps, then it is not the Rogue.
Tube preamps are usually not as quiet as solid state, but is would be the normal hiss sound that would be louder, not a hum.
mingles
796 posts
 
There is an audible humming from the listening chair 10ft. away.
Just to be clear... is it hum or hiss? If it's hum, the advice above is all very good. If it's hiss, I suggest replacing the tubes with low noise variants. Tube hiss is common, but it can be fixed.
mingles
796 posts
 
You should read this 10Audio review:

http://www.10audio.com/rogue_metis.htm

Particularly noteworthy:

"Downsides? A few. The Rogue is loud. There's much more spurious noise through my 89 db sensitive Soliloquy 6.2s than I'd like, and not just tube rush. I did have some issues with hum as well. Listen carefully and you can hear this from your chair at around ten feet."
bar81
791 posts
 
Is any noise with no signal "acceptable"?
fruff1976 OP
103 posts
 
I'd say hum and hiss + buzzing. It's just noise which can be heard in the room when the unit is turned on. About 20 seconds after you turn it on the buzzing/hissing/humming starts.
More to discover