Temperature of McCormack DNA-1?

Steve,
Thanks for the info. As usual, you're a class act.
I dug out a couple of small 12 volt fans I have, but they're kinda noisy. The amp is in a cabinet that's open front and back, but the sides are close to the sides of the amp.
I may have to get it out of the cabinet.
What would be the safe continuous high temperature?
Ben.

Hi Ben -

It's no big deal if the heatsinks get very hot, so long as the ambient temperature inside the amp stays relatively cool. The amp can operate at temperatures that would burn you, but the fact remains that heat is the enemy of component longevity. So, the cooler you can keep your amp, the better off you are. If you have the option of removing your DNA-1 from its cabinet, that would be helpful. If not, I am sure that you can find some quiet fans at your local computer parts store (especially multi-speed switchable types). If you do get it out of the cabinet, don't set it directly on a floor with thick carpet - use some sort of riser or feet like TipToes cones. This will allow free air movement around the amp, which is the key to keeping it cool.

Best regards,

Steve McCormack
SMc Audio

I posed a similar question about a year ago about my stock DNA-225. I've since moved it from a somewhat enclosed cabinet to a rack that is open on all four sides and has about an eight inch clearance to the shelf above it. She's fine now; just somewhat warm. Steve, thanks again for your response back then.

MikeB.

Greetings all. I'm thinking about putting a stock McCormack DNA-1 in my cabinet that is only 8" high BUT has screens in the front and right side and the rear of the cabinet can be removed to let air in as well as help with routing of ICs. The cabinet is the U-22D from Studiotech.

Now from reading the above replies I looked at the space in my cabiet and find that I'm able to place 4 Antec 120mm computer case fans lined up in a row on the sides of each heat sink of the DNA 1 or any other amp with heat sinks on the side. I'd be blowing air right onto the heatsinks. Each fan spins at 1200 RPM, 39 CFM Air Flow and has a noise level of 25 dBA.

Would this be ok in terms of keeping the amp cool? Would I be sending heat to the middle of the DNA-1 and making things worse for the amp's reliability in the long run or would I be cooling the unit down in general? Would it be better for me to have the rows of fans on each side face the other way and try to blow the heat from the heat sinks away from the DNA-1?

Sorry for the stupid questions & thanks in advance.

The trick is to keep the air moving through the enclosure so that heat will not build-up. What you have proposed should work fine, but you might get better results by positioning the fans to pull air in on one side and push it out on the other. You don't need to move a lot of air volume quickly - just a "gentle breeze" will work well.

I hope you enjoy your DNA-1.

Best regards,

Steve McCormack
SMc Audio