Lightspeed Attenuator - Best Preamp Ever?


The question is a bit rhetorical. No preamp is the best ever, and much depends on system context. I am starting this thread beacuase there is a lot of info on this preamp in a Music First Audio Passive...thread, an Slagle AVC Modules...thread and wanted to be sure that information on this amazing product did not get lost in those threads.

I suspect that many folks may give this preamp a try at $450, direct from Australia, so I thought it would be good for current owners and future owners to have a place to describe their experience with this preamp.

It is a passive preamp that uses light LEDs, rather than mechanical contacts, to alter resistance and thereby attenuation of the source signal. It has been extremely hot in the DIY community, since the maker of this preamp provided gernerously provided information on how to make one. The trick is that while there are few parts, getting it done right, the matching of the parts is time consuming and tricky, and to boot, most of use would solder our fingers together if we tried. At $450, don't bother. It is cased in a small chassis that is fully shielded alloy, it gets it's RF sink earth via the interconnects. Vibration doesn't come into it as there is nothing to get vibrated as it's passive, even the active led's are immune as they are gas element, no filaments. The feet I attach are soft silicon/sorbethane compound anyway just in case.

This is not audio jewelry with bling, but solidly made and there is little room (if any) for audionervosa or tweaking.

So is this the best preamp ever? It might be if you have a single source (though you could use a switch box), your source is 2v or higher, your IC from pre-amp to amp is less than 2m to keep capaitance low, your amp is 5kohm input or higher (most any tube amp), and your amp is relatively sensitive (1v input sensitivity or lower v would be just right). In other words, within a passive friendly system (you do have to give this some thought), this is the finest passive preamp I have ever heard, and I have has many ranging form resistor-based to TVCs and AVCs.

In my system, with my equipment, I think it is the best I have heard passive or active, but I lean towards prefering preamp neutrality and transparency, without loosing musicality, dynamics, or the handling of low bass and highs.

If you own one, what are your impressions versus anything you have heard?

Is it the best ever? I suspect for some it may be, and to say that for a $450 product makes it stupidgood.
pubul57
Thank you George,my intent is to let people know that your volume control isn't going to do nasty things if someone uses cables that are a different length from what you suggest.

I admit I was hesitant to try this configuration,but I wanted to remove all the gear from between my Acoustats,and long interconnects was the only way to do it.

The results have been terrific, nothing was lost and more was gained.

So, if interconnect issues and cable lengths are holding you back from trying the LSP,don't let that stop you from giving it a try in your system.

I run an Esoteric cd/sacd into it with short DIY silver/copper interconnects and out to the power amps with 20 foot quasi balanced RCA DIY interconnects,the type of wire is unknown to me,made for me about 20 years ago.Nothing fancy,especially the RCA's.

The LSP is not a component that requires the owner to only use a specific type of cable as some gear specify.

Nothing will be damaged,treat it with the same type of wiring and respect as any other pre-amp.

Now I am left with the audiophile's curse of wondering how much better it could get with some name brand 20 foot interconnect.

Fortunately/unfortunately, there's not a lot of the good stuff out there to try in 20 ft lengths.
Just thought you owners of the Lightspeed Attenuator would like to know, that it has made it again into 2013 Octobers Stereophile Recommended Components, with the highest $$$ value rating once more.

Cheers George
Well well we have a winner here in the crib. Will report further truth shortly.
I finally heard a preamp that sounds better in my system. It's a Herron audio preamp that retailed for $4000. I guess that's as big a compliment as there is.