Lightspeed Attenuator - Best Preamp Ever?


The question is a bit rhetorical. No preamp is the best ever, and much depends on system context. I am starting this thread beacuase there is a lot of info on this preamp in a Music First Audio Passive...thread, an Slagle AVC Modules...thread and wanted to be sure that information on this amazing product did not get lost in those threads.

I suspect that many folks may give this preamp a try at $450, direct from Australia, so I thought it would be good for current owners and future owners to have a place to describe their experience with this preamp.

It is a passive preamp that uses light LEDs, rather than mechanical contacts, to alter resistance and thereby attenuation of the source signal. It has been extremely hot in the DIY community, since the maker of this preamp provided gernerously provided information on how to make one. The trick is that while there are few parts, getting it done right, the matching of the parts is time consuming and tricky, and to boot, most of use would solder our fingers together if we tried. At $450, don't bother. It is cased in a small chassis that is fully shielded alloy, it gets it's RF sink earth via the interconnects. Vibration doesn't come into it as there is nothing to get vibrated as it's passive, even the active led's are immune as they are gas element, no filaments. The feet I attach are soft silicon/sorbethane compound anyway just in case.

This is not audio jewelry with bling, but solidly made and there is little room (if any) for audionervosa or tweaking.

So is this the best preamp ever? It might be if you have a single source (though you could use a switch box), your source is 2v or higher, your IC from pre-amp to amp is less than 2m to keep capaitance low, your amp is 5kohm input or higher (most any tube amp), and your amp is relatively sensitive (1v input sensitivity or lower v would be just right). In other words, within a passive friendly system (you do have to give this some thought), this is the finest passive preamp I have ever heard, and I have has many ranging form resistor-based to TVCs and AVCs.

In my system, with my equipment, I think it is the best I have heard passive or active, but I lean towards prefering preamp neutrality and transparency, without loosing musicality, dynamics, or the handling of low bass and highs.

If you own one, what are your impressions versus anything you have heard?

Is it the best ever? I suspect for some it may be, and to say that for a $450 product makes it stupidgood.
pubul57
King,

The LAS did a way better job of letting me hear my Lamp L5 than the Placette. My goal here is for the VC/pre amp not to alter the sound of this great 3D sounding Dac. I am sure an active pre would give me a more .... Sound and add to the mix but the L5 has enough of all that so there is no need to add any other ingredient to the system.

The LSA is noise free and simply passes the L5 sound to my amps. I have a 3D sound stage if it's recorded as such. Not flat or 2D as that is not what the L5 is about. So the LSA guy is giving me the Lamp sound I know so well that the Placette just couldn't do.

So I hooked up some ASI LL SC/IC's to my system and it was an ear opener. I will keep them hooked in as they work well with my amps/speakers.
How long do I have to wait to see my post showing up when written. 2 days ago?
So I hooked up some ASI LL SC/IC's to my system and it was an ear opener. I will keep them hooked in as they work well with my amps/speakers.
I've been using ASI LL SC/ICs for years and no plans to try anything else. Happy to hear LSA is working out for you ...
Those who have a Lightspeed Attenuator and wishing to try a different power supply instead of going battery.
I've been shown this quite reasonable priced one which is a nice linear regulated product. And comes with the correct lead, plug and polarity (2.1mm center positive).
This is 9vdc @ 1A which fine for the Lightspeed Attenuator as it converts it down again with it's internal 5vdc regulator.

http://www.ab-system.hk/index.php?route=product/product&path=73&product_id=64

Cheers George
Georgelofi,
Have you tried this yourself? Does it improve on the sound over your stock power cable?