Lightspeed Attenuator - Best Preamp Ever?


The question is a bit rhetorical. No preamp is the best ever, and much depends on system context. I am starting this thread beacuase there is a lot of info on this preamp in a Music First Audio Passive...thread, an Slagle AVC Modules...thread and wanted to be sure that information on this amazing product did not get lost in those threads.

I suspect that many folks may give this preamp a try at $450, direct from Australia, so I thought it would be good for current owners and future owners to have a place to describe their experience with this preamp.

It is a passive preamp that uses light LEDs, rather than mechanical contacts, to alter resistance and thereby attenuation of the source signal. It has been extremely hot in the DIY community, since the maker of this preamp provided gernerously provided information on how to make one. The trick is that while there are few parts, getting it done right, the matching of the parts is time consuming and tricky, and to boot, most of use would solder our fingers together if we tried. At $450, don't bother. It is cased in a small chassis that is fully shielded alloy, it gets it's RF sink earth via the interconnects. Vibration doesn't come into it as there is nothing to get vibrated as it's passive, even the active led's are immune as they are gas element, no filaments. The feet I attach are soft silicon/sorbethane compound anyway just in case.

This is not audio jewelry with bling, but solidly made and there is little room (if any) for audionervosa or tweaking.

So is this the best preamp ever? It might be if you have a single source (though you could use a switch box), your source is 2v or higher, your IC from pre-amp to amp is less than 2m to keep capaitance low, your amp is 5kohm input or higher (most any tube amp), and your amp is relatively sensitive (1v input sensitivity or lower v would be just right). In other words, within a passive friendly system (you do have to give this some thought), this is the finest passive preamp I have ever heard, and I have has many ranging form resistor-based to TVCs and AVCs.

In my system, with my equipment, I think it is the best I have heard passive or active, but I lean towards prefering preamp neutrality and transparency, without loosing musicality, dynamics, or the handling of low bass and highs.

If you own one, what are your impressions versus anything you have heard?

Is it the best ever? I suspect for some it may be, and to say that for a $450 product makes it stupidgood.
pubul57
Just wanted to thank George for a great job well done with the lightspeed attenuator.. The music in my system has really opened up and I'm hearing instruments more clearly in background with better detail then I ever had before.. The instruments sound so realistic as if I was right there and the voice's are so clean and airy..

I'm running the lightspeed with pass labs x250.5, Oppo bpd-105 and Eggleston fountain 2 speakers and am very happy with the results after over 20 years of listening my search is at last over..

Thanks George for a great product with good customer service.
Dave
Great Passive Preamp. Received light speed from George two weeks ago. In my system the light speed has great dynamics and clarity. System is primaluna prologue five tube amp and Tyler acoustics PD 15 speakers. Thanks George for a wonderful product.
Hi everyone, I have a question about the TeraDaK U9VA power supply, which I recently bought. The ac input is too large for the 2.1mm connector used by the Lightspeed. I asked the TeraDak manufacturers how to convert the plugs but the language barrier is preventing me from getting an answer.

What adapter have the folks using the TeraDak with the Lightspeed been using? If you have an online link, that would be very helpful. Thanks.
Jult52: I just use whatever came stock with the unit; no adapters needed. I do note that the cord juts out a bit when plugged into the LSA, but it is powering the unit as it should.

Perhaps the Teradak people changed their stock cord?
Never had any problems attaching the two with what came from TeraDak.
Perhaps you should contact them for the answer,and enlighten others who may want to purchase the "newer"units if in fact they have made a switch.
Perhaps they are offering an alternative to the previous cord.