Bi-Amp Basics - NHT 29s

Another Option
Use two Aragon 8008X3's and pick up a NHT SW3 Slave and you would have one awesome 5.1 and 2 channel system. The Aragon's work great with the NHT's also. Not sure if these are within your budget. But just a suggestion.

Get a NHT X2 active crossover and a pair of NHT A1 monoblock amps to bi-amp the 2.9's subs. They are much better than the older SA-2/SA-3 amp/crossover combos. This will also give you more control over the bass by allowing you to dial in flat response for music, and at the same time, a little extra "boom" for movie soundtracks' LFE content. Then, for the 2.9's upper frequncy drivers, since they are high passed at 100 Hz, power rating simply isn't as critical. Go for quality over quantity.

Also, replace those dipole HDP2 surrounds with a pair of new Evolution L5 on wall surrounds on closeout from ListenUp.com, which are phase-matched to the 2.9s/AC-2.

If you do these things, I guarantee you that you will be happy with your system for many more years to come.

Follow Markruss' advice of using an active crossover to bi-amp. Power amps w/o active filtering MUST have matched gain AND sensitivity to provide an accurate frequency response when used to bi-amp(or at least input attenuators). An active crossover will give you the ability/flexibility to balance whatever power amps you choose with one another.

Im a bit confused. If I did not want to use an active crossover, how would I bi-amp the 2.9's?

I am thinking of using Tubes for the Top end, and my Parasound for the bottom end.

Well as Rodman touched on above, you would have to have amps on the top and bottom ends with equal gain if you didn't use the X2 as they would be sharing the same volume control, so unless the tube amp and Parasound you want to use just happened to have matching gain, which I highly doubt they do, you really can't without the X2.

Go to NHT.com and download the X2 owner's manual for more on this.

Hope that helps.