Hissing and Hum through speakers

What speakers are you using and how sensitive are they?

If they are close to 100db then you may need a quieter amp.

they are the Jamo C809, 89db...6 ohms..

I plugged my ipod in directly to the amp just for the heck of it (headphone out so that I can adjust the volume,) and it seems like the slight hum that I had went way down, but the hissing sound from the tweeters is definetelly there...

Not sure it is the amp, I think it is AC line noise but wouldn't that be more in the form of a hum instead of hissing tweeter sound?

Thanks guys...

The hum is probably a ground loop. I don't think the hiss is AC related.

You might try a different set of speakers to see if your still getting the hiss. Are the speakers new?

The reason the hum went down with the ipod is because it runs on a battery and isn't causing a ground loop. PS audio sells power cords that have a removable ground pin. Do a search on ground loops you'll find lots of info on them because they are a common problem.

You've eliminated the preamp and source as the problem so its got to be the amp or speakers. Since you've tried different amps that leaves the speakers.

You might try plugging the whole system into another circuit to see if that changes anything.

I don't think that your results with nothing connected to the amp are meaningful, unless you connect shorting plugs to the inputs (which will probably kill both the hiss and the hum, especially given that you initially reported that the noise went away when you had the preamp connected and muted).

As an experiment, I'd suggest connecting the preamp to the amp, a source component to the preamp, and the ac cords of ALL of these components either to the Panamax (if it can handle the current requirements), or else to the wall without the Panamax. That will eliminate the possibility that some or all of your problem is caused by voltage differentials between the grounds/chassis of the different components.

Not sure what you meant by "there possibly seems to be some level matching issues with the 561 (45 Ohms output impedance) and the amp (23.5K ohms input impedance on the rca inputs.)" Ideally preamp output impedance should be as low as possible, and power amp input impedance as high as possible. Those numbers sound fine, although the amp's input impedance is probably lower than typical, which might result in signal loss if the preamp output impedance were unusually high (which it is not).

Regards,
-- Al