2. amps-preamps
  3. 1246480147

Audio Research CA50 + tube rolling

I recently purchased an ARC CA50 which I like a lot. It betters the Cary SLI-80 sig IMO but that's beside the point.
My question is about tube rolling. Has anyone tried rolling either power or driver tubes in the CA50 and what were the results ?

The only info on the net regarding this is somewhat paranoid thread on diyAudio advising against this and suggesting that ARC designed this amp around Sovtek/EH 6922s
Personally I don't buy it.

I contacted ARC and spoke to some bland dude who I don't think even knew what the CA50 was.
He blurted out something about adjusting the voltage on the side panels of the amp if I want to change the driver tubes.

Anyway, your thoughts, suggestions, advice and experience (good or bad) with tube rolling in this amp will be greatly appreciated.

Thanks in advance to all replies.
akanrg
akanrg OP
15 posts
 
If this is true then the design is wrong and arrogant !
I mean, one of the joys of owning tube equipment is to be able swap tubes every once in a while isn't it ?
akanrg OP
15 posts
 
p.s. is there anyone out there who actually owns the CA50 and tried tube rolling with it ?
rodman99999
6,156 posts
 
7308/6922/6H23/E88CC/CV2492/E188CC are all just 6DJ8 variants, and direct replacements. No voltage adjustment should be necessary. Any paired tubes in any circuit should be balanced/matched, triode to triode and to one another in the case of his 6922's. Any responsible tube seller would have seen to that(like Kevin at Upscale), if the application was mentioned.
testpilot
936 posts
 
I had a CA50 and the ONLY thing that I really disliked about it was the fact that the voltage needed to be changed/adjusted whenever your swapped out the driver tubes. I would call AR back and ask to speak to someone more seasoned, they will be able confirm the procedure. Yes, you can just drop in new tubes w/o adjusting the voltage but it will not be optimized plus it will shorten the tube's life. The CA50 is not a friendly tube roller's amp. Also, AR uses the Sovtek because the circuit is tough on tubes and the Sovtek have a reputation for being rugged. I tried using NOS tubes but the amp ate them within 6 months (I never adjusted the voltage) and I did nit want to send the amp back to AR as they requested.
akanrg OP
15 posts
 
Testpilot, which NOS tubes did you try ?
More to discover