".. I wasn't suggesting that Spectron requires it"
Hello Rich,
I am terrible speller but ...I can read. Read again your statement:
".....does it make any sense to look at other high-end Monoblocks, that don't require Bridging, or Bi-Amping? "
... see again this word: "REQUIRE"
Moreover, neither did you or any other contributor (as far as I could note) to this thread mention immensely important, I would say vital conditions of bi-amp versus monoblocks. For example, if Brian speakers use active crossover then he MUST use bi-amp, he has no choice or if monoblocks operation is in FULLY balanced mode (FULLY as in from amp input to the speaker binding posts) - which change immensely sound presentation - and please, not to confuse with balanced input which require XLR. I use my amps in full balanced mode using single ended RCA inputs (just two of them: "plus" and "minus" thus fullfilling definition of "balanced").
From Spectron web site (note that in first phrase instead of power outputs they mention efficiency of speakers):
"Regardless of the efficiency of the speakers, balanced mode of operation doubles the slew rate and bandwidth by virtue of the out of phase transmission. This also suppresses the noise and buzz originated upstream from the amplifier. The other major advantage of fully balanced mode in Spectron amplifiers is that transmission of both positive and negative signals (in each amplifier) is maintained separately from the amplifier's input to the speakers binding posts. Assuming that the signal path electronics are matched, all of the intrinsic amplifier distortions arrive at the speakers with practically identical amplitude but with opposed polarity and essentially cancel each other. The result is a largely noise and distortion free sound transmission, leading to a spectacular improvement in three-dimensionality and resolution of detail in the music"
And, if yourself would try two Spectrons first as two stereo amps and then as two monoblocks you would HEAR, HEAR immense improvements in the sound, like huge veil is removed and instruments are razor sharp located, and with their IMPROVED palpability "look" like a statues within huge soundstage etc etc. Anyone with two ears would hear it.
I am not alone - see reviews of other owners of monoblocks on-line, see professional reviews - by now may 10, look on their awards - just Best Sound at CES alone should say something.
I describe Spectrons only because original questions was directed at these amps and I use them for five years. You and others so far did describe other amplifiers (may be better, I don;t know) other situations for sure etc. Brian ask simple question - deserves simple answer.
If you want to compare Spectrons to other amplifiers in identical mode of operation (i.e. stereo vs stereo and mono vs mono), particualrly fully balanced mode then you MUST compare part tolerance first of all. As Spectron web site stated (see above) that if parts matching is excellent then distortions are canceled and thus if there is mismatching then new resulting distortion could be equal or worse or much worse then original stereo distortions. So go ahead, compare - this forum is all about it - just apples with apples, please.
Good Luck
Rafael
