ICE amps vs analog amps for bass


I'm currently running Legacy Helix loudspeakers. The bass and subwoofers are being driven by two pair of 500 watt ICE amplifier modules while the Midrange and treble frequencies are being driven by two pair of Levinson 436 amplifiers. While originally auditioning the speakers I heard them with analog amps on the bass, treble, and midrange sections and the sound was superb. However, I was assured that the ICE amps would be sufficient to drive the bass sections so I've given them a try. However the bass sounds funny. I don't hear the impact, definition, and subtle "spatial cues" that I know are in the recordings.
I partially am blaming the ICE modules. I'd sure like some input in solving the problem. I can "upgrade" to "analog" amps for the bass if I choose, but for space reasons and economic reasons, would prefer to continue to use the ICE amps. I'm considering Parasound JC-1s, or Bryston 7bs, for the bass if I switch.
Thanks for your help in advance.
Steve
128x128sgr
Icepower 500 ASP I believe two per speaker. I'll have to check further with Legacy. Also the impedence is 4 ohms and I don't know the sensitivity although the speakers are very efficient at over 98db. Please go to the Legacy Audio site and read about the speakers. The amps are directly plugged into the wall, and I assume always on, as they play as soon as I send a signal to them from the preamp.
Steve, how many hours have you played music on those speakers? Can I assume the bass amps are the Legacy PowerBlocks?
I don't believe they are the Powerblocks. They appear to be unmodified ICE Power Modules. Yes they have played more than 500 houes as I've had them sinse May.
my response would probably fall under the category of "covering all the bases" and you've probably already thought about it, but i would just make sure your cables are up to the job. seems like they sould sound good with decent power, interconnect, and speaker cables.

my martin logan summits (which i believe use ice modules in them to power the woofers) react quite differently to which interconnect (and power cable) is used for the bass frequencies - and to a lesser extent, speaker wire.

quite a few interconnects i've tried with them make them sound slower and woolier (i feed the panels and the woofers separately). i've had very good luck with silver interconnects on the bass, you could try a mac ultra silver, for example, for a ridiculously low cost.

good luck
Parasound JC-1's for the bass would be like drinking a top-shelf Burgundy with a taco - they're better than your Levinson monoblocks and would sound superb full-range on your Legacy's.

You may not have an A/C power supply that's sympathetic to Class D amplification. If you could get a hold of a power supply for the ICe modules, like Rowland's power supply, you would get a lot more performance.

That said, I again suggest running your Legacy's full-range with JC-1's, or even better, going with a much lower wattage amp like Pass's XA series or the darTZeel. A 98 db. efficient speaker gives you the luxury of avoiding high-powered amps, which require feedback to stabilize the circuit and have too many output devices to provide natural sound.