Conrad Johnson Premium 12 - Noise when turned on

Had an even simpler thought. Once you have isolated which mono, use a 6550 tube out of the amp which is OK. This way,
you won't order a tube you don't need. I would order it anyway just to have spares though. It's been a while since I had my 8A's. Normally a red light indicates a bad tube.
However, in this case it just may be a noisy one. I always loved the Premier 16 combo w/ my 8A's.

Thanks Fjn04. I will find time to do the exercise. Hopefully its just a bad tube.

Sounds like a tube may be ready to go bad. If the tube was already bad the amp should have blown the plate fuse which is indicated by the red light on the top of the amp chassis as mentioned above. You should try to isolate the problem quickly before the fuse blows. Once the fuse blows you will have to replace the fuse before swapping tubes around and then you must figure out which tube is going/has gone bad before the fuse blows again. I just went through this with my Premier 12’s and at $15 a piece each time you have to replace a fuse it can add up very quickly.

BTW, I use the Premier 16 with my 12's....GREAT combo.

I can concur 100% with both things Jaffeassc said. I used a Premier 16 1 and then an Art 1 w/ my 8A's. I only upgraded to the Art for a screamin deal dealer demo. Honestly, I felt very content w/ the 16. Never tried either in series 2. Try to hear one, or take a chance on a used one. I doubt you will be sorry. That said, if you are happy with your preamp, buy more music and enjoy.

Thank you guys. I did as Fjn04 said and was able to find the bad tube. Now the noise is gone and everything is good again.

Also thanks for the advise on premier 16, I might try to get one and put it in my system one day.