Tube Nube questions


I am beginning to roll output tubes in my Primaluna Prologue 2 . What is an average amount of time for new tubes to burn in ?

When I have a handle , after burn in , on the new tubes how long should I need to warm up the old tubes on a warmed up amp to make a fair comparison ?

Thank you .
saki70
I agree with newbee within an hour. My figure is 25 hours for a set of KT88's.
Ok thanks .

Just to make sure that I have it right . You are saying that putting cold tubes into a 'warmed up' amp will still take the same amount of time to come to full sound as when the amp and tubes are both cold ?

By the way , where does Kevin Deal have the biasing procedure printed .
If your amp is already warmed up it shouldn't take long when the tubes are already broken in. I've never timed it because I don't try to do instant A/B comparisons. Differences in short term listening sessions can be subtle and completely missed, and things that sound really impressive initially can over the long haul wear on you, compared to listening for the possible changes for a few days or so when most things will reveal themselves. I would allow at least 15 to 30 minutes so everything settles in. It is not a science however, but it will be a waste of time if you don't take your time in making comparisons.

Re the bias instructions - http://www.primaluna-usa.com/autobiasadjustment.htm. If you can't find and download copies send me an email with your fax number and I fax a copy to you.
Newbee;
I have it , thank you so much .
Did you find a need for a bias adjustment with tubes other than the 6L6's ?
I also have a PL1 in which I have used EL34's - while warmish in tone, a balance I can enjoy, it seemed a little peaky in the upper mid's which I don't enjoy. I rebiased it with my tubes in place. Now it is a bit warmer in tone and no longer peaky. In all honesty a bit too warm for my taste, but that's just me. Re the PL1, I also tried several different KT88's and 6550's 'because I could' and they were unrepresentative of what I expected from them - I suspect I could improve this unit by re-biasing it with them in place but I don't need to so it will remain a mystery.

Have fun with your tube rolling - keep in mind it's all about synergy not only with your amp but with your other electronics as well, so blanket recommendations from folks can be a waste of time and money. :-)