Inverted Amplifiers

Any of the methods indicated in the thread I linked to, or that Stan referred to, will allow you to determine the correct setting of the 0/180 switch, without first determining if the amplifier inverts.

Alternatively, you could contact the amplifier manufacturer and ask them. And sometimes their literature or website pages will indicate inverting or non-inverting. If nothing is indicated, as Elizabeth said the chances are it is non-inverting.

If you have the wrong setting, the symptom will be very weak reproduction of bass frequencies that are in the region of the crossover frequency. Nothing will be harmed, though, if that is not clear.

However, unless the sub's literature indicates it is ok to do so, it might be best to avoid changing the setting of the 0/180 switch while power is on, to prevent the possibility of transient thumps that may occur as the switch is being changed.

Regards,
-- Al

Several questions relate to this subject, beginning with: can you hear a difference?

To further explain Elizabeth's comments, an odd number of gain stages will invert the phase, an even number will retain the input phase. And as Stanwal states, an inverting preamp/line stage can be corrected by reversing one end of your speaker leads. But that will change all signals feeding the preamp as well. If you have a separate phono stage and it inverts and you also have other sources, that should be corrected by reversing the hot and ground connections on the cartridge.

For your subwoofers, you have two choices. Contact the manufacturer of your amp and ask if it inverts. Or test by ear as Al recommended. If you are not familiar with phasing, some test CDs (Stereophile's for one) provide a repeated track recorded in phase and out of phase. Listening to something like that without your subwoofers active may help to identify what to listen for.

Many thnks to all of the commentators! Your information should help me get the most out of my system.

I had and HAVE a pre with absolute phase switch.
Some material it can make a difference, but for R+R, which has had the phase data beaten out of it, it makes no difference. Multi miked anything is almost alway a mess, as well.
The most difference I have noted is on Solo instruments and than it is subtle and clearly preference driven.