Jolida integrated with remote and pre-outs?

Realremo - is your question about the pre-outs because you want to be able to connect the Jolida to a subwoofer in your 2.1 system?

If so, another option, and one that is preferred by a good many subwoofer manufacturers, is to connect the speaker terminals on the amp to high-level inputs on the subwoofer, rather than go from line-level outputs on the amp to corresponding inputs on the sub.

Sorry if that's not pertinent to your question but your mention of wanting to run a 2.1 system made me think it might be.

Sfar, so I can connect both the speaker wires and wires for the sub to the same speaker terminals without hindering the sound? The jolida only has a single pair of speaker terminals.
I have read that the high-level connection gives you better synching between the sub and the speakers for music.
I was also thinking about high-passing my bookshelf speakers through the powered sub, but this requires a main-amp-in connection on the amp, very few integrateds have these.
Interesting that Soundgasm got more than he expected! I guess Jolida, the company itself, is the only authority on what exactly their back panels look like, but their responsiveness is as sparse as their website...
Jolida 1501RC has better looks than the NAD line, but I would lose the ability to high-pass my bookshelf speakers...

Realremo - yes, that's exactly the way to do it if you want to use the high-level inputs on the sub and have only one set of speaker terminals. I used that kind of connection on an HSU sub, at HSU's recommendation, and am doing the same on a Mirage sub now.

As HSU explained it to me, with a powered sub all that's coming from the speaker terminal connections on the amp to the sub is frequency and amplitude information, very little current is actually moving through the cables and it has no effect on the signal going to the main speakers. They said, in fact, that you don't even need the same gauge or quality of speaker wires as are going from the amp to your main speakers.

On my amp with five-way binding posts I connected the main speaker cables with spades and used bananas plugged into the ends of the terminals for cables going to the sub. I tried the setup with both the high and low-level connections to the sub and found it much easier to integrate the sub using the high-level connections, even without the ability to high-pass the speakers.

Bob_reynolds, what about high-passing the speakers using the speaker terminals on the powered sub? If the sub has two pairs of terminals, the signal goes through these terminals and then out to the speakers - certainly some subs out there have active crossovers at the terminals going out to the speakers. Not all subs have low-level RCA outputs back to the amp. If I try to high-pass the speakers using these terminals, what powers the 2 speakers - the amp in the NAD or the amp in the powered sub? Are there any disadvantages in this technique?
Also - what do you think of HSU's line of subs? Do they have any that would fit your crossover criteria?