What direction should Hi Fi tune fuse be installed

Fun reading. No one has made mention of the directionality of wire due to the drawing process. The crystalline structure of copper is aligned a certain way when it is pulled through the die. What I am not sure of, is if the crystalline structure alignment changes when the copper wire is annealed or flexed. This may play some part in the fuse orientation question. The fuse manufacturer buys the wire in spools and so must know the actual direction the wire was pulled through the die. Otherwise, the directional notation on their fuses would be meaningless.

Mt T- The crystalline molecular structure actually forms in a sort of directional chevron formation(ie: >>>>>>), when drawn. The barriers(between crystals) are subject to oxidation and are thought to have a diode effect. I've been wondering (given the much greater complexity of musical wave forms, compared to the ordinary sine waves, used in testing/scientific experimentation), if this might contribute to a sort of Wood Effect, when the signal is subjected to those boundaries. The differences in ambiance, image specificity, etc., that some people(myself included) are able to perceive when speakers are reversed in phase, are as subtle as what some claim for fuse reversal. Again; I've not played with reversing my fuses. I'm just speculating.

How that may work in the case of fuses used in the power supply circuitry; I couldn't say. Perhaps, the multitude of minute diode bridges, somehow has an effect of the AC waveform, in one direction, more than the other. I haven't yet heard anyone mentioning OHNO Continuous Cast wire, in their fuses.

I know this: a few decades ago, I had some Monster Cable ICs with directional arrows. I had changed something on my stereo and had the ICs off of it. These ICs were going from preamp to amp. After reconnecting everything, I sat down to listen; but something didn't seem right. I couldn't put my finger on it; but it was enough to prompt me to get out of my chair and check everything. I found one of the two IC cables was plugged in backwards, ie. the arrow on the cable was pointing the wrong way. I corrected the orientation and sat back down to listen. Everything was good. That blew me away. I became more open minded about cables and other tweaks after that. I have not, however, gotten motivated to trial fuses.

If the impedance of Cu wire is slightly different in the direction of the draw vs. the other direction, then I would think that this difference is measurable. Perhaps fuse and cable companies know this and measure this; but for the sake of competitive advantage, do not care to reveal it. If wire impedance is slightly higher in one direction than the other, then it could follow that signal noise is slightly lower pending orientation of the wire. Lower signal noise could be perceived as better sound quality.

So who among these esteemed EE's could perform these delicate measurements? And be willing? Or is it nonsense?