2. amps-preamps
  3. 1265925791

How to replace volume pot in Dynaco Pas

I have just aquired a Dynaco Pas 2 preamp. I would like to replace the funky volume pot.I have a alps style pot and I also have a stepped attenuator to use.Both the Alps and the Stepped Atenuator have 6 lugs for connecting.The stock Pas pot has 12 lugs. Normally there would be R-in,gnd.,R-out,L-in,gnd.,L-out.That's six.
The pas has 12 and a couple of caps connected as well. Can anyone enlighten me on how to change this out?

thanks in advance.

e
emorrisiv
Post removed 
emorrisiv OP
313 posts
 
Thanks for the help. I have done the tone control defeat. I have been to the Dynaco Doctor site and it is quite helpful, but I didn't see anything on the volume pot. I will go back and look again.
My Pas 2 is the later model that looks just like the Pas 3 and all the caps have been replaced. I didn't do the work so I am not sure what they were replaced with.
Any and all help is very appreciated.

thanks so much.

e
emorrisiv OP
313 posts
 
I went back to Dynaco Doctor and I couldn't find anything about the volume pot.If you have a link,could you post it up?

thanks

e
Post removed 
More to discover