2. amps-preamps
  3. 1272513925

I need some amplifier help

I have an Adcom 555 and an Adcom 555II. Right now I am using them to power a pair of B & W DM640. I am using the 555 for the left ch and the 555II for the right ch. Should I keep it this way or change it to one amp for the low end and one amp for the high end? Just wondering because of the fact that the 2 amps are not exactly the same. Also, am I losing a lot of signal splitting the lefts and rights coming out of the preamp and is there any other way of doing it? I split the left to both ch of one amp and the same with the rights. Any suggestions will be appreciated.
joeseppe
rwwear
2,880 posts
 
Your speakers have a sensitivity rating of 91db and will probably play as loud as you would ever want to hear them with a good 35 wpc tube amp with a bigger sound and better dynamics

Maybe better sound? But not better dynamics. The B&W's like power and current.
weseixas
519 posts
 

I would use one for the bass the other for the top. Bi-amping this way is absolutely the best way.

Your speaker will sound better bi-amp ( all will ) the only issue you have to be aware of is the load impedance to your Pre-amp. If your pre cannot drive the combined impedance of both amps the sound could be degraded. Cables make a another big difference here because of such, but absolutely the best way to go if done right...
pubul57
3,712 posts
 
Could be better dynamics, depends on the tube amp. But if it is true that the B&W need current (low, and variable impedance)they may very well need an SS amp to sound their best.
chashas1
596 posts
 
Yes, definitely put one amp on top and one on bottom. Most definitely....there's no other way.

Could I ask, how did you arrive at your current setup? I mean the amp hookup....

Take care
Chas
rodman99999
6,188 posts
 
"There's no other way?" What he's doing is called, "vertical bi-amping"( http://www.caryaudio.com/articles/bi_amping.shtml ), the other method, "horizontal bi-amping."( http://www.roydaudio.com/articles/bi-amping-royds-passively/ ) Then, of course, there is active bi-amping(which is the best method).
More to discover