A big thanks to all of you that have tried to help. I was put in touch with the Tube Store and at their recommendation for my specific Xindak MT3 Integrated I ended up buying a matched pair of EH 6SN7, One Preferred AO Series 7025 12AX7, and 4 matched Winged C (SED) EL 34 for $212 total. I should have them by next week and then the tube journey begins, and I must confess I hope to see some improvement even if ever so slightly. Boy owning Tube gear is much more fun the Solid State
New To Tubes Advice Needed
Hi Guys:
Like my question says I'm very new to the world of tubes. I have recently purchased a Xindak MT3 tube Integrated and I'm very pleased with the warm sound it produces in comparison to all the SS amplifiers that I have used over the years. I based my decision to purchase the Xindak based on the sound I heard and not the fact that the unit is made in China. This being my first entry to the world of tube gear cost was somewhat of a concern just in case I did not like the sound in the long run. The unit runs on 4-EL34, 2-68NP (6SN7GT)and one 12AX7 stock tubes original to the unit. I have read that tube rolling could yield some good improvements, since I know nothing on the subject I was wondering if I could impose on some knowledgeable members to guide in so far as to what should be changed and what with. I'm aware that there is so many different tubes on the market and that buying one over the other is a matter of taste but in my case I'm totally in the dark so any guidance is valued.By the way I would like to keep the cost factor in to play so no suggestions for very expensive tubes. Also I have read that EL34 could be substituted with KT77 what is the difference.
Thanks in advance for all of your input.
RossQ
Like my question says I'm very new to the world of tubes. I have recently purchased a Xindak MT3 tube Integrated and I'm very pleased with the warm sound it produces in comparison to all the SS amplifiers that I have used over the years. I based my decision to purchase the Xindak based on the sound I heard and not the fact that the unit is made in China. This being my first entry to the world of tube gear cost was somewhat of a concern just in case I did not like the sound in the long run. The unit runs on 4-EL34, 2-68NP (6SN7GT)and one 12AX7 stock tubes original to the unit. I have read that tube rolling could yield some good improvements, since I know nothing on the subject I was wondering if I could impose on some knowledgeable members to guide in so far as to what should be changed and what with. I'm aware that there is so many different tubes on the market and that buying one over the other is a matter of taste but in my case I'm totally in the dark so any guidance is valued.By the way I would like to keep the cost factor in to play so no suggestions for very expensive tubes. Also I have read that EL34 could be substituted with KT77 what is the difference.
Thanks in advance for all of your input.
RossQ
- ...
- 16 posts total
- 16 posts total