2. amps-preamps
  3. 1289699022

new to tubes

i have never had any tube equipment and am thinking about trying it out. i am learning slowly about it and thinking about taking a leap with a lower priced piece. i currently have a Cambridge Audio 840v2 integrated amp and a pair of Fritz Grove monitors. my only source is a Squeezebox Touch. i already plan to get an Eastern Electric Dac. my only concern is how much power is enough to drive the groves as they are only 86db efficient. my room is only 13'x 11' treated,and i dont listen past 92 db. i'm thinking on the lines of a Jolida 502b to start. trying to stay under $1000 used. any thoughts?
rayray8
rleff
1,065 posts
 
What did the manufacturer recommend for using tubes for amplification?
atmasphere's avatar
atmasphere
11,806 posts
 
If the amplifier has an output impedance that is low enough, you can have variations in impedance that will not result in tonality issues with most tube amps, as long as the variations are not extreme. For example, a 4 ohm dip at a crossover frequency can be considered benign.

A lot has to do with the intention of the designer of the speaker- if the speaker is designed to be friendly to tubes, that is usually more important than the actual impedances.
rayray8 OP
51 posts
 
spoke with Fritz and tubes are a definite go!
Post removed 
rayray8 OP
51 posts
 
tvad, its an 8 ohm speaker and im sure it dips lower at different frequencies but most tube amps including the one i ordered have 4 and 8 ohm taps. all i have to do is try each output and decide on which i like.
More to discover