Setting up monoblocks

I guess i could have described the amps a little better for clarity, especially the a/b button which is important.

I am still a little unsure on the rear speaker setup. Do i keep the left front and left rear on one amp etc, or do I crossover the rears and do front right left rear etc. on one amp.
I figured I would ask and look foolish then not ask and do everything twice. Thanks

Well, you can do whatever you want, it will work either way. However, you will not get "surround" sound if that is what you are looking unless you feed one amp w front signal from an AV processor/pre and one amp w the rear. Also make sure that your amps can handle the lower impedance that you get from running two sets of speakers in parallel if you have the A and b speakers selected simultaneously. IOW, if your "front" and "rear" speakers are 4 ohm nominal and 2 ohm minimum, then the amp would need to be stable into a 2 ohm nominal and 1 ohm minimum load.

Thanks, I am not a huge movie fan so surround is not an issue . Bringing up the ohms is now confusing so I guess I have more reading to do this afternoon. I do know that my speakers are ,

Frequency Response: 43Hz – 20KHz

Suitable Amplifier Power Range: 15-200watts

Impedance: 6 ohms

Sensitivity - Room / Anechoic: 91.5dB/88.5dB

and the amps are .

Rated power: 250 watts into 8 ohms, 20Hz-20kHz, <0.02% THD, 450 watts into 4 ohms, DIN 1 kHz

Dynamic power: 650 watts into 4 ohms, 1100 watts into 1 ohm

Hi Eagleflyerfan,
I had those amps and they satisfied me almost twenty years. They were very good.Enjoy them.
I had them hooked up right mono amp handling front and rear right, and left amp handle left side.
I didn't use a pre.Ran them directly from cdp.The 'A' controlled the front speakers and the 'B' took care of the rear.

Regards,

Thanks Montejay, I have a bad habit of over complicating things. I figured that was the setup, but it was also nice to hear from someone whom actually used the amps.
I still need to figure out the amp impedance to the speaker etc. theory but I should be able to Google that to find out what is going on there.

Thanks again everyone for your help.