2. amps-preamps
  3. 1296334400

Phase inverting problem

Hello,

I have a Conrad Johnson PV-12A pre-amp. It is phase correct for the phono stage, phase inverting for the line stage.

My power amplifier is a conrad johnson MF2100. It is phase correct.

So my first idea was to connect the speakers to the power amplifier the wrong way (black to red, red to black) and then connect the cartridge the wrong way around as well (R: + and - reversed, L: + and - reversed). Then the phase should be correct for everything.

But there lies the problem. When I switch the connections on the cartridge, I get a really loud hum, makes the music barely hearable. Perhaps it has something to do with the fact that R- is connected to the cartridge body, it is some kind of earth? Anyway, switching the connections on the cartridge is not an option. So, what to do?

My only idea so far is, seeing that I only have one line input (cd), is cutting open the RCA cable and switching + and - of the line, and connecting the speakers to the power amp the correct way. So, I'll do just that. But maybe there's a better solution that I'm missing. Any ideas?
swaf
hifitime
715 posts
 
Definitely don't switch the interconnect wires. Way to many risks in doing that. The only way I can think of doing this without getting a different preamp, would be to add a switch to each speaker wire. That way, you can flip a pair of switches and reverse the speaker polarity. It can be done with a pair of double pole, double throw switches.
hifitime
715 posts
 
I found a picture on the net for wiring the switches that way. It's a lot easier than trying to explain it. It's the second picture from the bottom, and even shows two. The view is from the rear of the switch, with it flipping/sliding up and down.
[http://www.1728.com/project2.htm]
ahendler
416 posts
 
As Almarg said since the phono stage plays thru the line stage just reverse the leads on your speakers and both phono and cd will be in absolute phase. Get it
magfan
1,583 posts
 
Can you REALLY tell? Most people can't, and given the way modern music is recorded, no wonder.
Modern music is a jumble of phase, sometimes recorded in different places days apart.
I doubt any recording engineer pays any attention to absolute phase coherency.
hifitime
715 posts
 
Swaf said the minus is tied to his cartridge body. So when he reverses them, the plus may be tied to the whole tonearm. That would explain the hum. Then if he grounded the whole arm with the cartridge wires reversed, it might short the signal (plus)to ground also.
More to discover