Tweaking the Magnepan 1.7s

For purposes of a test, you can ignore the directions. Try any and all of the 4 logical ways they can be arranged.
1. mylar to listener, tweeters out (per directions)
2. Swap 'em L/R for mylar to listener, tweeters IN.
3. Rotate in place: results in mylar away, tweeters out
4. Swap em back L/R for tweeters IN and mylar away from listener.

#1 is Magnepan preferred.
#4 is the way I have my panels.

I'll go with whatever YOU prefer, in your system! It's too easy NOT to try, don't you think?

My original MG-1s were mylar away. I am told that sometime in the '90s, Magnepan decided to face the mylar TO the listener.

This will be the cheapest tweak you EVER try. Even removing the fuse will cost a few grams of solder and the electricity to heat up your soldering iron.

OH, each swap will require a little effort to optimize. When I did the rotate, they fell so naturally into place I have yet to mess with them again. But, I've been setting up panels for a long time and can get 'em pretty close to perfect in pretty good time. Perfect setup? takes longer.

I do want to mention a "tweak" that is not specific to Magnepan that has worked incredibly well. I ordered 4' x 2' x 2" sound absorption panels. I place one on each side of my audio system (which sits between the two speakers). I find the best set up when the two panels, one on the right and one on the left, are turn at a 45 degree angle facing the listener.

There is an immediate increase in clarity due to the reduction of reflections off of the audio equipment rack. The music is much more focused and instruments are more easily located in space (although, I have still not gotten the 3D effect of musicians spread out behind the speakers to any major degree).

I have been incredibly lazy and not finished off my new listening area, as yet. Have to paint the room and remove a rather large rear projection TV out of the space. When I have it set up, I will try once again with the reversed positioning.

One final note, I believe the Magnepans continue to get better over time. I have had them for about 5 months and for the first time the other evening, I heard a very familiar Rodrigo Y Gabriela CD but with a difference. For the first time the two guitars in several of the selections seemed to be floating behind the speakers about 3-4 feet. Most of the time, I get very realistic and natural sounding instruments without much depth. This was spooky real and what keeps me "tweaking" my system.

Just ordered XLR cables from BetterCables to connect my Wyred 4 Sound to my Bada Preamp. This is my first test of XLR cables vs. RCA and I didn't want to spend too much money if it wasn't going to make a difference. We'll see.

Mylar front, Tweeters in is Magnepan suggested placement on 1.7's.

I read the 1.7 manual on the magnepan website. Tweeters in! you bet!
Mylar front is how they come.....which puts the connection panel in back, safely out of tripping range and sight.
I'd try it both ways....ALL 4, actually, since you can either do a L/R swap or a simply rotation-in-place.
That give 4 logical ways to place 'em....any of which may yield the best results in any given room.

Do not take for a reading teacher. But the Mag 1.7 manual does notspecifically recommend one tweeter position(in or out) or the other. It does recommend ' tweeter out' on the 1.6's. I have read the print vesion that accompanies the 1.7 and the on line manual which are exactly the same. I have found that leaving the tweether 'out' fit the geometry of my room. I suspect the magnetic side is smoother but will not risk tripping on the wires and the frontal 'normal view ' gives visual pleasure.