2. amps-preamps
  3. 1305582339

Setting tube bias

I have a TAD 60 tube amplifier and I alternately run EL-34 (both regular bias and single ended class A bias) and KT88 tubes. I tried to switch out the EL-34 to the KT 88 and I can't set the bias adjustment low enough to keep them from going very high very quickly. No matter how many turns I go to the left, the bias keeps going up. This has never happened before and I'm not sure what is going on.

I went back to the EL-34 tubes and had no problem setting the bias. This is just happening with the KT-88 tubes. They are the same tubes I've run before so it isn't a new tubes issue.

Any help would be great. Thanks.
gmsasso
hifihvn
943 posts
 
05-17-11: Gmsasso
Thanks all. It would be strange for all 4 KT-88s to go bad at the same time.

No one said all four have gone bad at once. You need to test all four to see if any of them are bad. In most cases, that's the easiest, and cheapest method. If all the tubes are good, then get the amp checked for a bias problem.
atmasphere's avatar
atmasphere
12,014 posts
 
I agree with Gmsasso- it *is* strange for all 4 tubes to be too 'hot' all at the same time. Really seems to point to the amp not having enough bias voltage in its bias supply.
hifihvn
943 posts
 
Atmasphere, if one tube has a short, couldn't it pull the minus bias voltage for the other three down with it? Also, possibly send positive voltage on the bias from one shorted tube? If this is the case, a tube tester may not show the defective tube either. A few years back, I had a new tube glow orange and show good on two testers, a Hickok and Eico 667. They exchanged it and put it back on the shelf. I ordered more, and got that same tube back. I returned it, they put it in an amp they had, and it glowed orange. The testers( theirs and mine) would not give enough voltage to show the defect.
hifihvn
943 posts
 
I guess another thing that would come into play, would be how much current the bias can supply in the amp. It is not something to play with since it can put to much of a load on the transformers too.
gmsasso OP
33 posts
 
Thanks everyone. I tried the KTs again, one at a time, and it is still a problem. I'm taking the amp in for a check up.
More to discover