Two physical grounds??

Try running a #14 awg to the outlet that your power conditioner is using, to a cold water pipe and clamp off to that. Swap out the old two wire outlet to a new three wire grounded outlet. The NEC allows for this and will provide an equipment grounding conductor for your conditioner. You can also run an addition wire to a driven ground rod if you would like. Don’t have any idea where the neutral (grounded conduction) receives it’s ground reference and might result in noisy ground loop, if so you can buy various products to combat that and the conditioner is much safer with the grounded outlet. Good luck. T. J.

Tio, on the one hand you mention that "the house outlets are of [a] type that accept a 2 prong plug." On the other hand, when raising the possiblilty of installing a separate dedicated grounding rod for the line conditioner, you mention the new rod would be "about 16 feet away from the ground rod for the electrical wiring for my house."

I assume that the outlet in question is wired with two wire ungrounded romex. Ergo, why there's only a two plug outlet available for the line conditioner.

I hope I'm not being simple here, but if there is a grounding rod for the house, to what extent is the house wired with three wire grounded romex. That is, the various line circuits all converge to one place, the fuse or circuit box, which in turn, I assume is tied into the house ground, as required by most electric codes. If most of the house wiring is grounded romex, then you could run a new grounded romex line from the outlet that is dedicated to the line conditioner to the grounded socket.

However, if the house is old (like mine), most of the house wiring may only be old fashioned ungrounded two wire romex. If so, I like Tjt's idea the best. Maybe that would work if you can fish the ground through the wall and attach it to the water pipe.

Aren't multiple grounds as described....Against Code?

Also, Where do you find 2 prong (ungrounded) sockets?

Magfan, maybe they're really old?? Otherwise, I think most folks just slap a three prong into the outlet, but don't ground it.

As I mentioned in my post, my house is old, maybe built 50-55 years ago and was wired with 2 wire ungrounded romex. When we moved in about 18 years ago, we did a lot of home improvement and electrical work in the basement. While the basement ceiling was opened up, the electrician was able to rewire most of the 1st floor outlets with grounded romex. BTW, the electrician was licensed and his work was inspected by a township inspector to ensure all work was done in accordance with code.

FWIW

Back in the late 70s I lived in a house with 4 or 5 outlets TOTAL and push button/rocker switches for lights.
The service was Knob and Tube.....which was so old the code for it was written in Hieroglyphs. My dad, generally mello, freaked out when he saw it and 'bout demanded I move out........The house? One of the oldest in downtown Fullerton California and the very definition of 'fire trap'.

http://en.wikipedia.org/wiki/Knob_and_tube_wiring

I'm surprised. Your Romex may have been put in during a transition period between hard conduit and the newest 3-wire code. At least you didn't have Aluminum wire and fittings.
The house my dad built about '58 was all conduit which I think was the '3rd wire'.

Any of the 2-wire stuff left should be immediately upgraded to latest code. Some of the wiring...J-boxes, outlets and switches may be untouched for decades and ready-2-go.

I'm still a little......leery.....of multiple ground rods.....