Two physical grounds??

Magfan, maybe it's is a local thing, but every licensed electrician who has been in the house for one reason or another says that as long as we don't mess with the old romex and don't overload the outlets, the old stuff is stable.

To undertake what I think you are suggesting, which is to change out the old 2 wire romex, would entail ripping the house apart. Most of the old wire is attached to the studwork. As I mentioned above, when the occassion arises, we always try to change over circuits to comply with modern code.

But what about the OP?? I wonder what his situation is. Btw, I'm not an electrician, so take this with a grain of salt, but I don't like the idea of two ground rods either.

If there are no other grounds, tying the two earths together is appropriate and does not create a loop if I understand what the OP is describing. The tie wire should be the same type of ground strap used from the service panel.

I'm not an electrician either. But you might be able to get a new ungrounded outlet somewhere. Another option would be to use a ground fault circuit interrupter, and I believe it needs to be labeled ungrounded on it. The extra ground rod is not an option, unless you bond them all at the service ground, per NEC, and local codes. Again I'm not an electrician. I am going by memory FWIW. That's not saying much with these middle age "senior moments". Gotta blame something.

Also make sure the hot (phase) wire and neutral are correct. There are some older products out there that have one wire tied to the case/chassis. If it's backwards, that can be a deadly mistake.

Thank you all for your responses! As some of you guessed right the house is very old with just 2 prong sockets (ungrounded). However, I know that there is a ground bar at the fuse box which would be very difficult to fish in order to tie the two ground bars togheter. Tjtrout20 suggestion seems to be the way to go. Thanks again!