2. amps-preamps
  3. 1311278935

Question: DAC too hot & want to add sub

I have just started to get into non-headphone listening and wanted to get some recommendations for my 2.1 setup.

My current setup -
Speakers: Ascend Acoustics 340se for L/R.
Transport: Sony dvp-s7000 > Coax
Dac: Highly Modified Zhoulo 2.5 > 6 Channel Direct (L/R)
Amp: Harmon Kardon AVR500

So far sounds great, really immersive but the DAC signal is alittle too "hot" and I dont get alot of play on the amp potentiometer. I also want to add a small sub (condo listening).

Questions:
1. Would a preamp able to attenuate a "hot" Dac?

2. What is the recommended method of adding a sub?

So far I think its:
A. Add preamp which has sub out and can cut low frequency to main speakers. Like Parasound 2100 but a variable crossover for main would be great.

B. Use sub's own crossover and match the cut off frequency of the main speakers. This also presents many options, as I am bypassing the AVR's digital controls; I cannot set main speakers to small/large and am not sure if the sub pre-outs also work on the AVR/amp. Worst case I can use sub's speaker inputs from amp to sub then to main speakers which would filter out the low frequency.

C. Buy/build active crossover.

Budget is around 500-700.
Any advise much appreciated.
keyid
keyid OP
2 posts
 
The sound im hearing from the setup so far good; kinda warm but yea im sure better amp would help (looking at building aleph-x). But the "hot" im referring to is not the highs, they are very clean and bass passages are decent; the speakers go up to 45hz and want a subwoofer for the extra lows.

I added a zapfilter my dac and replaced all power supplies with shunt regulators; I think the zap filter is outputting too high of a gain. My play on the amp is only couple of degrees before its way too loud. The voltage on the output of the dac is less than 1mv; so I think its the gain.
bondmanp
1,811 posts
 
The problem with using a subwoofer's internal crossovers is that they are often an afterthought; an accomodation for consumers who lack a sub-out RCA jack or an AVR with built in crossovers. The quality can be poor, and remember, the entire audio band, not just the bass, will be run through this crossover.

I myself use a subwoofer for each of my left and right channels, and I would not want to be without them. However, I am planning on upgrading the outboard crossover my subs use for the reason I stated above.

Does the H-K AVR have a Treble level control? You could just nudge it a bit lower. That might be all you need, especially since you seem to like the sound with the exception of the too-hot treble.

And Plato has a good point. Consider some sound absorption at the first reflection points. Parts Express sells low-cost acoustic foam panels, if you don't mind the "studio look". Is your floor carpeted? If not, consider a rug for the space between you and the speakers. If you like the sound of headphones with your system, it may well be the room acoustics (or even the loudspeakers) that are the problem.
keyid OP
2 posts
 
thank you for all your replies, the treble is good as is; I shouldnt have used "hot" to describe my problem.

I think im going to build a passive preamp using octocouplers like the lightspeed attenuator since my avr input impedance is 47k and zapfilter output is 100ohms. Should give me more room to control volume on the amp to find that low volume sweet spot.

As for the sub, still have to find better solution or pay for some Rel subwoofers.
Post removed 
More to discover