TRL Dude or Joule 150 MKII for Major Pre Upgrade

No, don't solder a resistor between the RCA and pin 1 of the tube socket. That would put the 1K in parallel with the 100 ohms, resulting in an overall resistance of about 91 ohms.

Hopefully you can unsolder the wire that is presently connected to the RCA jack, and put the resistor in series (i.e., connected between that wire and the RCA jack). That would result in an overall resistance of 1100 ohms.

It might be a surer bet, though, to use a resistor having a higher value, such as the 3K or 4K values I mentioned. The main constraint on how high a value should be used is, I believe, that if it gets too high the bandwidth of the low pass filter formed by that resistance and the input capacitance seen looking into the grid of the tube, based on the Miller Effect, will reduce the overall bandwidth of the amplifier (which is spec'd at 150 kHz). Calculating from the 6SN7 data in my tube manual, I believe that 4K would still be low enough to not have a significant effect on that bandwidth.

Best regards,
-- Al

All depends on how long that curcuit trace is from the RCA hot pin to pin1.
If its less than 3 inches then a 1k grid stop in series ie
UNSOLDER RCA hot and put 1k inline.
SOLDER Socket-hot-->1k-->wire to grid@6sn7.
But if its any longer then you will need help from Aesthetix.

The 1000 ohm value on pin 1 (grid) represents the grid stop resistance at the input. That is not the problem.

Ralph, the present (original) value is 100 ohms. Do you still feel that is not the problem?

Best regards,
-- Al

Acck! I now have to say hold everything cos I just looked at my NP220PG and the grid stops to the 6SN7 (also in diff amp config) is 100 Ohms. They are place after the grid leak which is 100k to ground.
So if my NP100PG is so darn quiet and EM free even with crappy cables whats up with Grannyring's Aesthetix?
My NP has very low gain though, my speakers are 89-90dB efficiency.