2. amps-preamps
  3. 1329437943

Sonic improvement with Threshold FET 9 refurb?

Hi All,
In a recent post I was asking if anyone knew of an affordable ($1200 or so) sonic step up from my ARC SP14 preamp since a threshold FET 9 I had recently aquired from a fellow Agoner did not, to my ears. sound quite as transparent and holographic as the SP14. Very,very nice, yes, but not a step up. I didn't get any suggestions other than to upgrade the SP14 electronics and a comment that there was probably no affordable step up.
Anyway, after re-reviewing the glowing write-ups on the FET 9, I'm wondering if, despite its nearly pristine condition inside and out, my example might be a bit "tired". I realize that there is significant controversy about the need for capacitor replacement and or power supply upgrades and don't want to spend a lot of money trying to fix somethhing that is really working as well as it can, but am wondering if this might be sonically worthwhile. I would greatly appreciate hearing from anyone who has actual experience with this or a parallel scenario.
Thanks!
drjay
drjay OP
27 posts
 
Thanks for the input so far. My unit is the original with no e on the unit or power supply. I knew there was an e but was not aware that there was a "full e" that had more than just the upgraded outboard power supply. Are there substantial sonic differences?
Thanks Again
swanny76109
382 posts
 
Contact Jon Soderberg at vintageamprepair. He is a Threshold/Forte expert rebuilder.
tls49's avatar
tls49
1,351 posts
 
The “e” power supply was the most significant upgrade. Later the main unit was tweaked, with the addition of balanced input/output, and a slight cosmetic change.

Absolutely contact Jon Soderberg, he was at Threshold for many years during that time. I’m sure he could make your FET9 perform as well as any out there.
drjay OP
27 posts
 
Thanks Folks,
I will contact Jon Soderberg next week but am still wondering if, following refurbishing, my unit will be an improvement sonically on my ARC SP14. If anyone out there has had a chance to compare a properly functioning "well tuned" FET9 or FET9e to an ARC SP14 I would greatly appreciate your impressions.
Thanks!
unsound
7,329 posts
 
FWIW, as far as I can tell the differences between the FET 10 and the FET 10e is that the e series has a beefier external power supply with completely removable (and possibly upgradable?) umbilical cord, a set of XLR inputs and outputs (though neither set is truly differentially balanced), slightly different control options and layout, with different knobs and other cosmetics. I would think that the 9 series would have similar differences, and that a standard FET with e series power supply, would be at the very least comparable to a "full blown" e series.
More to discover