Get yourself two multimeters and bias it by yourself. On the scale form 1 to 10, I would rate it as 2 - easy DIY project. 15 minutes and you are done (then you will have to recheck in 1h or so).
Pass Labs heatsinks temperature
Hi all
I have Pass Labs xa60.5 monoblocks and they are always warm to the touch at the heatsinks and not as hot as other class A amps I'm familiar with. A friend from the US that has the same model visited my place and told me his amps ran very much hotter than mine. I got concerned and looked at the manual where temperature was estimated at 55 degrees Celsius. I estimate mine at around 40 Degrees. I'm concerned my amps are not biased to pure class A as they should be. I contacted Pass and while they repeated that heat should be around 55 deg. they had no idea if my concerns are valid and they sounded quite mysterious about it. Did anyone has a xa.5 series model ever measured its temperature or has an idea what can I measure without opening the amps (with a technician) that will prove that they are working only in pure class A ?
Thanks in advance
I have Pass Labs xa60.5 monoblocks and they are always warm to the touch at the heatsinks and not as hot as other class A amps I'm familiar with. A friend from the US that has the same model visited my place and told me his amps ran very much hotter than mine. I got concerned and looked at the manual where temperature was estimated at 55 degrees Celsius. I estimate mine at around 40 Degrees. I'm concerned my amps are not biased to pure class A as they should be. I contacted Pass and while they repeated that heat should be around 55 deg. they had no idea if my concerns are valid and they sounded quite mysterious about it. Did anyone has a xa.5 series model ever measured its temperature or has an idea what can I measure without opening the amps (with a technician) that will prove that they are working only in pure class A ?
Thanks in advance
- ...
- 28 posts total
- 28 posts total